搜索资源列表
rp-pppoe-3.6.tar
- 在linux上实现拨号上网的功能，可以在平台arm上运行，移植性比较好。-on dial-up capabilities in the platform arm run transplanted better.
rp-pppoe.tar
- 此软件包含linux下rp-pppoe程序，解压缩后增加到内核中-under linux rp - PPPOE procedures to decompress after kernel
rp-pppoe-3.8.tar
- 一个拨号程序还不错，但有些地方还需要改进-a dial-up procedure was pretty good, but some areas need improvement
rp-pppoe-3.8
- rp-pppoe-3.8是在RED HAT系列Linux中所使用的拨号上网程序，采用PPPOE协议，实现了其协议栈。-rp - PPPOE - 3.8 in RED HAT series of Linux used by the dial-up Internet access procedures used PPPOE agreement, achieved its protocol stack.
rp-pppoe-3.4.tar
- 0. Install the rp-pppoe-software -------------------------------- You should have already done this by the time you re reading this. If not, go back and read README. 1. Set up your Ethernet hardware --------------------------------
rp-pppoe
- 基于linux的PPPoe驱动的实现，非常好，阅读之后，感觉很好，特此与大家共享
rfc4938-1.00
- This project provides an open source (GPLv2) pppoe client implementation of RFC4938, “PPP Over Ethernet (PPPoE) Extensions for Credit Flow and Link Metrics” and the IETF draft, draft-bberry-pppoe-scaled-credits-metrics-01.txt, “PPP Over Ethernet (P
Comparator_CALC
- 很方便的迟滞比较器计算程序，省去了令人厌烦的手工计算步骤！只需要输入迟滞比较器类型（同相、反相）和上下门限以及比较器工作电压即可得到比较器外围数据！（软件上还包含一个建议电路示意图！）-Very convenient comparator hysteresis calculation procedures, eliminating the tedious manual calculation steps! Only need to input hysteresis comparator type