搜索资源列表
-
0下载：
SuperIO对应CPU和系统温度的主板风扇转速读写控制程序。-SuperIO CPU and system temperature corresponding to the motherboard fan speed control program to read and write.
-
-
0下载：
EMC单片机非常有用的资料，
某遥控风扇详细注释
C语言生成温度B值表
探讨可移植性的处理办法.doc
汇编的模块化思想.doc
代码严格的模块化.doc
ELAN单片机上电清空RAM区.doc,EMC SCM is very useful information, a remote control fan detailed explanatory note C language generation of portable temperature B value table app
-
-
0下载：
SuperIO对应CPU和系统温度的主板风扇转速读写控制程序。-SuperIO CPU and system temperature corresponding to the motherboard fan speed control program to read and write.
-
-
0下载：
一个基于单片机的智能温度控制系统，能够检测现在的温度，并且通过电机控制风扇降温-A microcontroller-based intelligent temperature control system is able to detect the current temperature, and cooling fan motor control
-
-
0下载：
实现蓝牙控制等，喷淋阀，风扇，安全通道，18B20，温湿度传感器等传感器的实现。(The realization of Bluetooth control, spray valve, fan, safety channel, 18B20, temperature and humidity sensors and other sensors.)
-
-
0下载：
能用遥控器开关开启风扇并检测温度调节风扇转速(The fan can be turned on with the remote control switch, and the temperature is adjusted and the fan speed is adjusted)
-
-
0下载：
12c5a的程序 温湿度 时钟 也精细显示 可燃气体报警 湿度检测 光照强度检测 通风扇控制 步进电机控制(12c5a procedures, temperature, humidity, clock is also a fine display of flammable gas alarm, humidity detection, light intensity detection, fan control, stepper motor control)
-
-
0下载：
空调扇触摸按键控制，空调扇定时，温度检测，LED显示(Air conditioning fan, touch key control, air conditioning fan timing, temperature detection, LED display)
-
-
0下载：
above document is a source code for home automation system using pic16f877a. in the code when motion is detected the home light will turn on and the speed of home fan is control by using temperature
-
-
0下载：
本系统就是充分利用了8051芯片的I/O引脚。系统以采用MCS-51系列单片机89c51为中心器件来设计简易温控风扇系统，实现了能根据设置的上下限温度，来启动风扇的工作与停止，低于设置的下限温度，风扇不工作，在上限与下限之间风扇以50%的转速工作，温度高于上限，风扇全速工作。(This system is to make full use of the I/O pin of the 8051 chip. The system uses MCS-51 series microcontroller
-
-
0下载：
以stc12c5a60s2单片机为控制中心，通过温度传感器采集温度数据，由单片机处理后调节风扇速度。风扇有手动调节模式和温度调节模式。(Taking STC12C5A60S2 microcontroller as control center, temperature data is collected through temperature sensor, and then speed is adjusted by MCU. The fan has manual adjustment mode
-
