搜索资源列表
42pcb
- 该工程是一个FPGA的开发板 主要包括了FPGA芯片:EP3C25Q240C8 FPGA的配置芯片采用：EPCS16 USB芯片：CY7C68013A USB的FLASH采用：24LC64 AD芯片：AD9238 电源部分：LMS1117-3.3两块分别对USB、模拟部分和FPGA供电；LMS1117-1.2为FPGA核心电压；LMS1117-2.5为 IO口及PLL供电 9盏LED，4个开关 主要完成的一个功能是高速模拟信号的采集，以及上位机传输
UART_rec
- fpga 串口通信 本程序在fpga开发板上实验成功-fpga serial communication program in fpga development board in this experiment was a success
ourdev_187634
- fpga 串口通信 本程序在fpga开发板上实验成功-fpga serial communication program in fpga development board in this experiment was a success
parall_ad_da
- 并行DA和AD转换，能够成功实现其功能。已在FPGA开发板上验证。实现较高的数据转换精度。-Parallel DA and AD conversion, to successfully achieve its function. FPGA development board has been verified. Achieve higher precision data conversion.
HAMMING_CODE_vhdl
- 用vhdl语言编写的汉明码的发送与接收，并在fpga开发板上实现-With the Hamming code written in vhdl sending and receiving, and fpga development board implementation
fpga_mcu_uart
- 用FPGA 开发板 SPARTAN3实现的串口程序，用XILINX 自带的ip核 -Achieved with the FPGA development board SPARTAN3 serial program that comes with the ip nuclear XILINX
UART
- fpga开发板与电脑进行串口通讯，实现了基于FPGA的串口接收发功能-fpga development board with a PC serial communications, FPGA-based serial port to receive hair
fpga1
- fpga黑金开发板原理图和pcb,对开发fpga硬件有帮助-fpga black gold development board schematic and pcb, Development fpga hardware
USB
- 此例程是基于FPGA的USB控制器实例，主要功能为通过FPGA芯片控制USB芯片，实现开发板和PC机之间的USB接口数据通信，来模拟一个硬件加密设备的功能。用Verilog语言实现。-This routine is an instance of the USB controller based on FPGA, the main function is to control USB chip by the FPGA chip, implement the USB interface for da
uart
- 黑金FPGA开发板串口收发程序，其中加入FIFO模块作为输入输出缓冲-Black gold development board FPGA procedures, which joined the FIFO module as input and output buffer
ceshi11
- FPGA开发板数码管按键测试程序 数码管跑数 独立按键控制数码管加一 开关控制数码管亮灭(FPGA development board digital tube key test program digital tube running number independent keystroke control digital tube add a switch to control the digital tube)