搜索资源列表
cdbh
- 差动保护中电流互感器二次回路的接地保护.-differential protection current transformer secondary circuit grounding protection.
byq10
- 能配合“变压器测试组件”实现LF2000系列各个型号变压器组件与互感器的测试任务要抗干扰能力强,操作方便,软件升级维护方便可复位保护功能,pic单片机c语言程序-line with the "transformer testing components" to achieve all LF2000 Series Model Transformer components Transformer Testing tasks to be anti-interference capa
dianliu
- 关于电流互感器的设计的文章,极具参考价值!
Vot
- TINA下绘制的用电压互感器采集220v电压信号的隔离放大电路。前级利用2mA/2mA电压互感器采样,将电压放大至0~3V。-TINA drawn under the acquisition with a voltage transformer 220v voltage signal isolation amplifier. Pre-sampling using 2mA/2mA voltage transformer, the voltage is amplified to 0 ~ 3V.
cc
- 故障指示器;单相接地故障;电流互感器;全波整流有效值电路;单片机-Fault Indicator Single-phase Ground Fault Current Transformer RMS circuit full-wave rectifier SCM
HGQ-H
- 我在公司做的基于430F206的互感器现场效验仪.有原理图印板图及源程序,已定型.-I 430F206-based company s well-tested instrument transformers at the scene. There are printed board schematic diagram and source code, have been stereotyped.
main1
- 仪器内部具有多变比的自升压电压互感器标准,准确度等级达到0.02级,可以在1200V和2400V的电压下准确检定电力电压互感器的误差。-I do school-based low-F206 main high-voltage transformer has been used in products.
OpenSource_72
- 我在公司做的基于430F206的互感器现场效验仪-At my company to do 430F206-based field-tested the instrument transformer
ddd
- 电流互感器手册电流互感器和变压器很相象,变压器在线路上,主要用来改变线路的电压, 而电流互感器接在线路上,主要用来改变线路的电流,所以电流互感器从前也叫做变流器-Current Transformer Handbook
caiyang_1
- 该程序为基于DSP C6713平台下的关于汇编程序模拟互感器的信号采集传送程序成功用于变电站110KV互感器的应用,内涵AD采集,FIR滤波,相位补偿,DFT有效值判断和输出~对于学习DSP内部寄存器和了解汇编程序有很大帮助!-The program is based on DSP C6713 platform assembler transfer analog signal acquisition program transformer substation 110KV transformer
digital-power-meter
- 利用AT89C52单片机和电压互感器来做的一个功率计。显示就是4位的LED。能够读书瞬时功率。-AT89C52 microcontroller and voltage transformer using a power meter to do. Shows that four of the LED. Instantaneous power can be read.
acquisition
- 电子式互感器离线校验系统的采集器程序,利用msp430开发的-Electronic Transformer collector system off-line calibration procedures developed by msp430
Ultrasonic-Power-supply-Device
- 本论文对国内外光电式电流互感器的供能方式进行了总结,论述了其优缺点。其中,基于超声波供能的光电式电流互感器是目前的最新研究成果,目前的研究已经验证了其可行性,但是存在传输效率低的严重问题。超声波供能系统的研究,需要大量的力学实验,不便于实现。本论文通过对力学中超声波的波动方程进行推导,寻找出了一组和电学中传输线方程相类似的方程组。通过对比电学和力学中的物理量,得到了它们之间的对应关系。在此基础上,构建出了超声波传能装置的等效电路模型,并进行了仿真实验。通过在电学中的仿真结果,较为直观的反应出了超
Cur
- 利用互感器采集电流的隔离放大电路,电路前级有光耦隔离。-Collected using current transformer isolation amplifier circuit, the circuit before the class with optical isolation.
GPRS.C
- 基于51单片机控制的GPRS模块,主要功能是检测三相交流电的的工作情况,用交流互感器检测三相的电流变化,传给单片机,单片机通过串口控制GPRS模块发送信息,这时可以了解电机的工作情况-Based on 51 single-chip control of the GPRS module, the main function is to detect the work of three-phase alternating current, AC three-phase current transfo
msp430cjq
- 基于MSP430单片机的电子式互感器采集器的程序,包括积分算法,AD采样SPI发送等环节-MSP430 microcontroller-based electronic transformer collector procedures, including the integration algorithm, AD sampling and other aspects of SPI transmit
ihd6500-lcd-07-09-11
- 基于ucos操作系统下的数字化电子式互感器合并单元的液晶显示程序,按键操作的程序-Ucos operating system based on digital electronic transformer consolidation program the liquid crystal display unit, key operation procedures
AD976_6channel
- 软件是适用于FPGA的VHDL程序,目的是用于满足IEC61850-9协议的电子式互感器采样,软件采用的是AD976芯片,能同时进行6个通道的采样。-The software is based on vhdl for FPGA,which is used for electronic transformer fulfil IEC6185-9 protocol.the AD chip is AD976,it works at the state of 6 channels at the same
mutual-inductor
- 对电流互感器 和电压互感器的描述,非常好的学习资料-mutual inductor, current and voltage
SD_power
- 本单相正弦波逆变电源的设计,以12V蓄电池作为输入,输出为36V、50Hz的标准正弦波交流电。该电源采用推挽升压和全桥逆变两级变换,在控制电路上,前级推挽升压电路采用SG3525芯片控制,闭环反馈;逆变部分采用驱动芯片IR2110进行全桥逆变,采用U3990F6完成SPWM的调制,后级输出采用电流互感器进行采样反馈,形成双重反馈环节,增加了电源的稳定性;在保护上,具有输出过载、短路保护、过流保护、空载保护等多重保护功能电路,增强了该电源的可靠性和安全性;输出交流电压通过AD637的真有效值转换后