搜索资源列表
c5402_ais
- AIS TI DSP 5402 的应用程序代码
DM643Bootloader
- 本文是介绍DM643x下进行程序移植过程的详细介绍。-This document describes the functionality of the DM643x ROM bootloader software. Please note that the ROM bootloader requires use of Application Image scr ipt (AIS) as the primary data format for loading code/data.
AISdeshujujiexi
- 基于ARM的AIS控制显示终端，用于接收AIS数据的解析打包-ARM-based AIS control and display terminal, for receiving AIS data analysis package
msg_jiema
- AIS的控制显示终端中接收数据包输的电文数据包包头-AIS display terminals to receive the control packet transmission of message data packet header
zhuangma
- AIS系统中控制显示终端数据的解析，ASCII码与6 BIT 的ASCII码之间的转换-AIS system control display terminal data analysis, ASCII, and 6 BIT conversion between the ASCII code
key
- 当按键每按下一次，学会检测按键，按键每按下一次，8个小灯亮灭交替一次-When pressing the button every time, learn test button, press the button each time, 8 hours a turn off lights 朗读显示对应的拉丁字符的拼音 字典- 查看字典详细内容 可翻译 50 多种语言س ل ح ف ا ة dětiPardon ??πα
AIS-System-Pattorm
- 根据通用船栽自动识别系统(AIS)的协议栈，给出了一种基于链路层、网络层和传输层的嵌入式系统AIS系统平台设计，详细研究了其基于ARM+FPGA的硬件设计和基于uC／OS—II操作系统的软件设计。-According to the protocol stack of tlle AIS．this paper proposes a design of the AIS system platform based on the embedded system foucs on link layer．ne
R-REC-M.1371-4-201004-I__MSW-E
- This Recommendation provides the technical characteristics of an automatic identification system (AIS) using time division multiple access in the VHF maritime mobile band.
AIS
- generate flash to emmbedded C6747
AIS3
- generate ais using c6747 TMS 320 TI
AIS
- 將經緯度資料轉換為AIS之AIVDM的NMEA語句，並輸出至串列埠。-Arduino program for translate Latitude and Longitude data into AIVDM NMEA phrase.
msg_jiema
- AIS的控制显示终端中接收数据包输的电文数据包包头-AIS display terminals to receive the control packet transmission of message data packet header
zhuangma
- AIS系统中控制显示终端数据的解析，ASCII码与6 BIT 的ASCII码之间的转换-AIS system control display terminal data analysis, ASCII, and 6 BIT conversion between the ASCII code
AIS
- AIS解码在数据处理程序中, 首先必须将接收的字符转换成ASC II码, 再调用校验程序, 对接收到的数据进行校验, 当校验正确后, 才能进行编码转换-AIS decoding data handler, you must first convert the received characters into ASC II code, and then call the calibration procedure, the received data checksum checksum is co