搜索资源列表
zigbee
- 基于zigbee的大型停车场设计C代码，包括cc2530发送串口数据，和接收到数据并转成串口给PC上位机。-Large parking lot design based on zigbee C code, including cc2530 send serial data, and convert the received serial data to the PC host computer.
ucos_ltck
- 立体停车场演示系统设计任务： 1）双层自动停车场配置如图1示，上下层共可停9部车； 2）本停车场设计的规则为5、6、7、8、9车位只能上下移动，不能左右移动，1、2、3、4车位只能左右移动，不能上下移动； 3）下排车位只需直接将车子开出即可； 4）停车场入口处有称重台，若车载负荷过大，将提示重量过大，拒绝存放； 4）如需要呼叫上排车子，只要按下5至9的按钮，再按下[取车]按钮，则所按车位将降至下层，而下排车位将左右移动，让出位置让上层车位降下。 -Parking l
carparkcontrolbaseonGSM
- ：介绍一种无人值守的停车场管理系统的设计。该系统前端主要由GsM 短信模块TC35i和AVR 单片机At— megal6组成，安装在停车场的每个进出口，通过接收车主的手机短信控制进出口道闸的开启并由短信扣取停车费用，各进出 口电路都与监控中心计算机连接。-: A unmanned car park management system design. The system front-end GsM messages by AVR module TC35i and At-megal6 co
Park
- 基于STM32F103RBT6的停车场模拟，使用了RTX操作系统-Parking lot on STM32F103RBT6 simulation, RTX operating system used
Micro-Proyecto1
- Program for an autonomous parking lot, it was written in MikroBasic for PIC Micro Controllers
car
- 智能停车场，本程序用的是STC12C5A60S2，程序已经在实际中适用-Intelligent parking lot, this procedure is used in the actual STC12C5A60S2, the program has been used in
newled
- 这是嵌入式比赛的样题，描述的是一个停车场，可以用串口收发数据。-This is a game-like embedded questions, describes a parking lot, can send and receive serial data.
parking_lot_rev1.0
- This Verilog source is to monitor the count of cars in 4 floors in parking lot. monitoring method is to use sensors to count Cars to enter into or leave out. Cars number is basic number enough small to learn algorithms.
at
- 收发短信,通知对方,这模块我们用过载基于嵌入式停车场的设计。-Send and receive text messages to inform each other, we used this module contains an embedded-based parking lot design.
counter
- 停车场计数器的设计，分别计数进入停车场的车辆数目和离开停车场的车辆数目。- The design of the parking lot counter, into the parking lot were counting the number of vehicles and leaving the parking lot number of vehicles.
lywpass
- 停车场的计时计费自动显示电路的EDA的VHDL语言课程设计-The parking lot of the timing and charging automatically show circuit EDA VHDL language curriculum design
car_count
- car_enter，car_exit分别表示有车辆进入停车场和离开停车场。count1和count2是两个计数器，分别计数进入停车场的车辆数目和离开停车场的车辆数目。total=count1-count2, 表示停在停车场中的车辆数目。lot_full表示停车场已满，即total的大小等于预置的停车场最大停车数（例如32）。 lot_empty表示停车场车辆数目为零。-car_enter, car_exit vehicles entering the car park and leave the
5.-ir-based-parking-system
- Embedded project for parking lot sensors
4.-IR-based-door-open-closed
- IR BASED PARKING LOT SYSTE-IR BASED PARKING LOT SYSTEMMM
parking-lot-system
- 这是一个小型项目，基于物联网的智能停车场管理系统，采用Cortex_a8平台，分为服务器端子系统、客户端子系统、RFID子系统、停车场收费子系统、Zigbee无线网络通信子系统、视频监控和抓拍子系统，由车辆射频识别、数据发送、数据采集、传输、GPRS通信、视频监控、图像传输、后端服务器和远程客户端等模块组成。-This is a small project, based on the Internet of Things intelligent parking management system
Frequency-divider
- 利用Verilog设计的在停车场情况下的模拟的分频器和计数器的代码-The use of Verilog design in the parking lot in case of analog frequency divider and counter code
Timing-
- 利用verilog设计的停车场中的计数器计时器和计费器，完成智能管理效果-Use the counter timer and meter parking lot in the Verilog design, intelligent management
停车场
- 第三届蓝桥杯模拟题 -模拟停车场计时收费(The third Blue Bridge Cup simulation questions - Simulation of parking lot time charges)
SmartPort
- 基本功能 1、车辆通过相关射频卡片由系统进行读取记录。 2、手机通过wifi模块实时看到停车场状态（是否有空位）。 3、控制自动编程计费。自动生成计费结果，按年，月，日，卡号。 4、设计交互屏幕，有提醒空停车位和缴费情况。(basic function 1, the vehicle is read and recorded by the system through the related radio frequency cards. 2, the mobile phone uses
bariyer
- barrier control of vehicles entering and leaving the parking lot is done with arduino uno card