搜索资源列表
source.rar
- 用S51单片机控制驱动芯片L298程序(C语言) 有六个端口,输入端口分别为P1.0,P1.1,P1.2,P1.3,P1.4,P1.5. 六个输出端口分别为P0.0,P0.1,P0.2,P0.3,P2.4,P2.5. 其中P0.0,P0.2,P2.5输出高低电平.P0.1,P0.3,P2.4输出PWM脉冲信号. 程序要求 只要P1.0-P1.5中任一个为"1",则P0.0,P0.2输出高电平 当P1.2或P1.3为"1",P0.1,P0.3输出占空比相同的PWM信号,With S5
stm32_PWM_Input_cepin
- 采用stm32内部TIM编程PWM输入模式 实现对输入信号的测频 可测1200HZ以上的频率值-TIM programming using stm32 internal PWM input mode Achieve the input signal frequency measurement Can be measured over the frequency 1200HZ
DZ60_ADC_TPM
- freescale dz60. LED1,2初始亮度为5 . 通过串口 输入指令 0x61 调节LED1的亮度为95 .输入指令 0x62，LED2亮度为95 ，同时LED1恢复为5 .-MCU:freescale dz60 Function: Brightness of 2 LED can be adjusted by input PWM signal. The PWM signal can be changed by SCI instruction.
ARM8962MyPWM
- 51tft驱动程序，ARM2148 tft驱动程序，ARM8962产生pwm，ARM8962中断中调整pwm，ARM8962 IO口输入输出-51tft driver, ARM2148 tft driver, ARM8962 generate pwm, ARM8962 interrupt adjust pwm, ARM8962 IO port input and output
M8_2400
- ATMEGA8_ LTC2400 6位半表头程序 LTC2400最高测量电压为5.3V，超过5.3V或反接都会烧掉。 模拟部分供电最好经过7815稳压，最高输入电压不宜超过18V。 模拟电路与数字电路分开供电。 不要使用开关电源或PWM升压、降压电路供电 -ATMEGA8_ LTC2400 6 ½ -digit meter program LTC2400 highest measured voltage is 5.3V, 5.3V or rev
PWM-Lamp-brightness
- “飞思卡尔”MC9S12XS128微控制器输出PWM的一个程序。-This is MC9S12XS128 MCU of freescale input a program of PWM.
STM32_PWM
- stm32的pwm输入功能的实现，程序已通过调试-STM32 PWM input functions of program through the debugging
PWM-input-mode
- STM32 PWM输入模式进行频率的测量-measure frequency by STM32 PWM inputmode
pwm_input
- A code to read a PWM input signal in an STM32 Board .
STM32_PWM
- 这是用STM32编写的一个PWM信号输出和输入捕获程序，频率和占空比可调-This is a PWM signal output and input capture STM32 written procedures, adjustable frequency and duty cycle
STM32-PWM-fre-and-
- STM32F103 -快速计算出输入PWM的脉宽和占空比及频率-STM32F103 - quickly calculate the pulse width and duty cycle and frequency of the PWM input
PWM-Input-Capture
- 在通过输入方波信号，可以通过STM32的输入捕捉功能，测出输入方波的频率。-Through the input square wave signal, you can STM32 input capture function, measured by the frequency of the input square wave
PWM-input-program2
- PWM输入模式捕捉4路PWM的周期和占空比-PWM input program
Stm32_Timer---input-capture-mode(timer2-Puart).ra
- configuration stm32f1xx to PWM mode by timer
crazepony-firmware-none-5.2
- PWM输入模式捕捉4路PWM的周期和占空比.rar-PWM input mode captures four PWM period and duty cycle .rar
PWMinput
- PWM输入模式捕捉4路PWM的周期和占空比-PWM input mode captures four PWM period and duty cycle
STM32--11-16
- STM32F103的ADC,12864液晶屏，PWM,脉冲输入捕捉-STM32F103 ADC, 12864 LCD screen, PWM, pulse input capture