搜索资源列表
ch452
- CH452按键和显示板驱动程序,采用级联方式,模拟SPI口一次发送24位数据.每级120个灯和120个按键.采用查表换算.-CH452 keys and display drivers, concatenation, a simulation of SPI I sent 24 data. Each level 120 lights and 120 keys. Using Lookup conversion.
AT91RM9200-BasicSPIDataFlash
- This zip describes SPI communication with a Serial DataFlash AT45DB and/or with a DataFlashCard AT45DCB. It shows how to configure the SPI peripheral on the AT91RM9200EK. Includes main.html file for help. For use under Green Hills 3.6.1 Multi?2000 So
ssc_sent_spi
- 在ads1.2上运行,适合高速的数据通信。数据可以以50Mbit/s的速度由ssc口进入,经过处理、过滤后由SPI口输出。其中使用了快速强制中断,处理效率很高。注意:本工程是汇编级程序,可读性差,但效率极高。-run in ads1.2 suitable for high-speed data communications. Data can be 50 Mbit / s rate from ssc I entered, processed, filtered output from SPI m
ILI9322.zip
- The attached zip includes a c code for initializing ILI9322 display chip used in many 3.5 TFT LCD devices. this is a SPI based initialization code in C which can be seamlessly ported to any architecture. I have also added the datasheet for easy refer
1381driver
- 本程序是完成的HT1381的驱动程序,定义SPI的三个端口后,可直接调试。我在仪表的时钟中得到成功应用!-This procedure is completed driver HT1381, the definition of the three SPI ports, may directly debugging. I clock in the instrument has been successfully applied!
ECU
- 以LPC2194为平台开发的整车ECU控制器程序,集成SPI,Can通讯,AD,I/O控制等功能。具有产品级的性能。-LPC2194 as a platform to develop procedures for the vehicle ECU controller, integrated SPI, Can communication, AD, I/O control functions. With product-level performance.
User_manual_2410x
- This manual describes SAMSUNG s S3C2410X 16/32-bit RISC microprocessor. This product is designed to provide hand-held devices and general applications with cost-effective, low-power, and high-performance microcontroller solution in small die size
userial-firmware-v1.6
- userial is an Free project building an USB to I2C/SPI/GPIO bridge, using the Atmel AT90USB647 chip. Hardware and Software are released under an Open Source licence. It supports the following interfaces: * USB interface (serial emulation) *
ads7870
- /// The basic specs of the ADS7870 are: /// - Fast SPI interface (up to 20MHz) /// - 12-bit results /// - 8 single-ended or 4 differential input channels /// - Programmable gain stage (1,2,4,5,8,10,16,20x gains) /// - Software or
PxGLCD
- Interfacing LPC2124 with GLCD : image display, data display and pixel ON/OFF. Adapted the code to fine tune and make robust. The proteus DSN file also contain temp sensor and SPI EEPROM. But the source code is only limited for GLCD displa
PxGLCD
- LPC2124 interfacing with Temp sensor TC1047A The temp is display on GLCD LM3228 Temp formatting is done for -40 C to +125 C only. This source code contains interface for Temp sensor and GLCD only. I m in the process of adding source code
STM32108PKT-SD
- STM32的SPI口SD卡程序,本人已经验证过,绝对能用,这个是一款开发板上的源码-The SPI port STM32 SD card program, I have verified, the absolute can be used, the source is a development board
STM32SST25VF016B-SPI
- STM32F103VET通过硬件SPI接口读写SST25VF016B,我验证过绝对能用,这是一款开发板上的源码-SPI interface to read and write through hardware STM32F103VET SST25VF016B, I can definitely proven, this is the source of a development board
AdTest
- AD7705D与ARM9的驱动程序,利用I/O口模拟SPI总线-AD7705D and ARM9 drivers to use I/O port simulation SPI bus
17_10_11_Batary-lcd_v1
- All examples of S65 LCD using on this page are for the following test board. I m using this board to check my code. The board has an AVR (ATmega16) controller running at 16MHz, 3.3V voltage regulator to power an LCD, the resistive dividers to shift t
lpcxpresso.getting.started
- The LPC1769 is a Cortex-M3 microcontroller for embedded applications featuring a high level of integration and low power consumption at frequencies of 120 MHz. Features include 512 kB of flash memory, 64 kB of data memory, Ethernet MAC, USB Device/Ho
arm7_88w8686
- ARM7(LPC)+88W8686(测试没问题)源代码,SPI模式,自己写的协议栈,只写到ICMP层,UDP层很简单就没写了 编写:wuhl QQ:365950965 没有动力写下去了,关键是我不懂WEP和WPA认证过程,本来可以抓包的,可惜没有相应的网卡,笔记本也坏了, 不然可以用笔记本抓包 东芝笔记本会突然熄火,真是不可思议 如果大家写好了加密认证的方法,麻烦把程序发给我一份,谢谢 这段程序已经调通,完全没有问题。但只能连接不叫米的无线路由器,希望集大家的力量完善它,
General-Purpose-Input-Output-
- GPIO:General Purpose Input Output (通用输入/输出)简称为GPIO,或总线扩展器,利用工业标准I2C、SMBus或SPI接口简化了I/O口的扩展-GPIO: General Purpose Input Output (general-purpose input/output) referred to as GPIO, or bus extension using the industry-standard I2C, SMBus or SPI interface
STM8-SPI-NRF24L01
- STM8的软件模拟SPI口写的NRF24L01程序,相信对于开发人员有很大帮助。-STM8 software simulation SPI port write NRF24L01 program, I believe there is a great help for developers.
OLIMEX-STM32F103-STK.ZIP
- This example project shows how to use the IAR Embedded Workbench for ARM to develop code for the Olimex STM32-103STK board. It shows basic use of parallel I/O, SPI, timer and interface to a LCD PCD8544 compatible module.