搜索资源列表
数字温度计
- 数字温度计的源程序和仿真文件 采用的是数字式18b20传感器
Thermometer_C51.rar
- 本资源内含基于单片机的数字温度计,资源包括Proteus仿真文件,C程序,原理图及PCB,This resource contains digital thermometer based on single-chip resources, including the Proteus simulation file, C procedures, schematics and PCB
mega48-1
- 用mega48-1制作低成本高精度的是数字温度计-Mega48-1 production by low-cost high-precision digital thermometer
C51
- C51入门模块和3个综合项目的原理图和源码，三个项目是CAN网络，GPS终端，带时钟的数字温度计。-C51 entry module and the three integrated projects schematics and source code, the three projects is the CAN network, GPS terminals, digital thermometer with clock.
DS18B20
- 单片机AT89c52 DS18B20数字温度计的设计 -Single-chip digital thermometer AT89c52 DS18B20 Design
DS18B20
- DSl820数字温度计提供9位(二进制)温度读数指示器件的温度信息经过单线接口送 入DSl820或从DSl820送出因此从主机CPU到DSl820仅需一条线(和地线)DSl820的电源可以由数据线本身提供而不需要外部电源因为每一个DSl820在出厂时已经给定了唯一的序号因此任意多个DSl820可以存放在同一条单线总线上这允许在许多不同的地方放置温度敏感器件DSl820的测量范围从-55到+125增量值为0.5可在l s(典型值)内把温度变换成数字-DSl820 digital thermom
onewayinterfacei
- 1DS18B20简介DS18B20数字温度计提供12位[二进制]温度读数,指示器件的温度。信息经过单线接口送入DS18B20或从DS18B20送出,因此从主机CPU到DS18B20仅需一条线[和地线],每一个DS18B20在出厂时已经给定了唯一的序号,因此任意多个DS18B20可以存放在同一条单线总线上。-DS18B20 brief introduction 1DS18B20 digital thermometer to provide 12-bit [binary] temperature r
shiyan2
- 单个DS18B20数字温度计测温C程序， 测温范围－30～110℃，误差在±0.0625℃，并把测得的温度显示在数码管上。-DS18B20 single figure C thermometer temperature measurement procedures, temperature range of-30 ~ 110 ℃, the error at ± 0.0625 ℃, and measured the temperature on display in the digital
51_DS1302_DS18B20
- 基于51单片机的数字时钟和数字温度计，可实现红外无线遥控设置，并由lcd显示数据-Based on 51 single-chip digital clock and digital thermometer, infrared wireless remote control can be set up implementation by the lcd display data
DS18B20
- ds18b20数字温度计，实现单片机S51控制，4位数码管显示-DS18B20 digital thermometer, single-chip implementation S51 control, four digital tube display
temper
- 此为课程设计的作品 为数字温度计的测量~ 希望对初学者有帮助-This is the work of curriculum design for the digital thermometer measuring ~ want to help beginners
DS18B20_test
- DS18B20数字温度计实验,用一片DS18B20构成测温系统，测量的温度的范围在0度到99度之间，用2位数码管显示出来,同时用一个发光管指示DS18B20是否在线,亮表示在线,熄灭表示不在线。-DS18B20 experimental digital thermometer with a temperature measurement system DS18B20 constitute, measurement of the temperature range of 0 degrees to
Single-chipapplication
- 单片机多个实用实验，包括数字温度计，电子密码锁设计，电子琴。所有的程序都有汇编和c语言对照。-Single-chip a number of practical experiments, including digital thermometers, electronic locks design, flower. All procedures are compiled and c language control.
wenduji
- 这是用热敏电阻传感器输出的电压模拟量经模数转换器转为数字量,再由单片机处理后由四位一体共阳数码管显示的数字温度计(高温可报警)-This is the voltage simulation quantity which outputs with the thermistor sensor transfers the digital quantity after the modulus switch, again after monolithic integrated circuit proces
Dtmdesign
- 利用8051单片机、常用数字逻辑接口器件、ROM、RAM存储器器件、单总线数字温度传感器DS18B20，设计一种基于单片机的数字温度计，温度检测范围为0-90度，要求能够通过键盘设定温度超限报警值，通过LED或LCD显示当前温度值。-The use of 8051, commonly used digital logic interface device, ROM, RAM memory devices, single-bus digital temperature sensor DS18B20
ds18b20
- msp430fw427单片机读写ds18b20，并把温度值显示到液晶显示器上，构成数字温度计-Single-chip msp430fw427 read and write ds18b20, and the temperature display on the LCD display, constitutes a digital thermometer
Fourdigitdigitalthermometer
- 基于AD590产生的四位数数字温度计，可接收的工作电压为4V－30V，检测的温度范围为－55℃－＋150℃-AD590 generated based on the four-digit digital thermometer, which can be received for working voltage 4V-30V, temperature range for the detection of-55 ℃-+150 ℃
wenduji
- 基于89c51单片机和ds18b20温度传感器的数字温度计源码，可以设定上下限，报警功能-Based on 89c51 microcontroller and a digital thermometer temperature sensor ds18b20 source code, you can set the upper and lower limits, alarm function
Designfortemperature
- 包括了基于89C51单片机的数字温度计的实现，详细的给出了所用器件及其原理图。-Including the 89C51 microcontroller-based digital thermometer to achieve, given the detailed and schematic diagram used in the device.
数字温度计
- 用C语言编程的数字温度计，适合于单片机使用。(The digital thermometer programmed by C language is used by single chip microcomputer.)