搜索资源列表
-
0下载：
硬件条件是STM32，CH375，VS1003和NOKIA5110，通过CH375和usb接口实现数据传输，利用STM32 SPI实现mp3播放，并有液晶汉字显示，画点画线的功能-Hardware condition is STM32, CH375, VS1003 and NOKIA5110, CH375 and usb interface through the data transmission, the use of STM32 SPI implementation mp3 player,
-
-
0下载：
vs1003底层驱动函数，使用STM32的SPI接口，包含正玄测试，RAM测试等等。-vs1003 bottom drive function, use the STM32' s SPI interface, including being mysterious test, RAM test and so on.
-
-
0下载：
基于STM32网络接口程序的代码，通过SPI控制网卡芯片ENC28J60-STM32 network interface based on the code, through the SPI control chip card ENC28J60
-
-
1下载：
SD卡底层驱动，使用STM32的SPI接口与SD卡通讯，采用SPI方式. 文件系统中TFF.C和TFF.H文件不需要改动，只需要改动SD卡操作函数即可即可。
-SD card low level drivers, use the STM32' s SPI communications interface and SD card using SPI mode. File system TFF.C and TFF.H file without changes, just need to c
-
-
1下载：
stm32意法单片机的完整的SPI接口程序，经测试很好-stm32 complete ST microcontroller SPI interface program, tested very well
-
-
0下载：
有关STM32单片机SPI接口使用的相关代码-STM32 MCU with SPI Interface on the relevant code
-
-
0下载：
网络芯片W5100驱动程序，主控为STM32，接口为SPI 只需要更改定义口即可立刻使用-Network chip W5100 driver, the master interface is SPI only need to change the definition of the mouth can be used immediately for the STM32
-
-
0下载：
基于STM32的触屏驱动代码，spi的接口-based on the pretext of the STM32 the touchscreen driver code, spi Interface
-
-
0下载：
stm32板上的SD卡的使用，通过SPI接口控制SD卡，不涉及文件系统，只是简单的实现底层读写接口，编译环境为IAR。-stm32 board SD card, SD card through the SPI interface to control the file system does not involve simply the realization of the underlying reader interface, IAR compiler environment.
-
-
0下载：
AT45DB flash与STM32通信，SPI接口。-AT45DB flash with STM32 communication SPI interface.
-
-
0下载：
STM32单片机通过SPI接口控制ST7565R液晶的代码-STM32 MCU through the SPI interface control ST7565R LCD code
-
-
1下载：
基于stm32固件库的两个SPI接口通信以及SPI的DMA通信。-Based on the STM32 firmware library, two SPI interface and SPI DMA communication.
-
-
0下载：
GPIO 模拟SPI 代码，主要基于STM32来用GPIO来模拟SPI功能。-SPI GPIO simulation code to use to simulate SPI GPIO function is mainly based STM32.
-
-
0下载：
STM32平台通过SPI接口对无线模块进行控制，实现无线收发通信，代码可以直接使用，没有bug-STM32 platform through the SPI interface to control the wireless module, realize wireless transceiver communication, code can be used directly, no bug
-
-
0下载：
STM32下使用SPI接口驱动GD25Q32flash的代码，代码采用模块化编程，清晰明了。-STM32 using the SPI interface to drive GD25Q32flash code, the code using modular programming, clear.
-
-
3下载：
官方GP22的使用例程，使用stm32的硬件SPI接口通讯控制，而不是采用网上常见的模拟SPI的通讯方式。模拟SPI通讯方式极大的限制了GP22处理的速度。(The official GP22 routine uses the STM32 hardware SPI interface communication control, rather than the use of common online analog SPI communication mode. Analog SPI commu
-
-
1下载：
stm32芯片与clrc663芯片通讯、spi接口程序、可实现读卡(Communication between STM32 and clrc663, SPI interface program and card reading)
-
-
2下载：
STM32测试复旦微SP1接口EEPROM(STM32 test Fudan micro SP1 interface EEPROM)
-
-
1下载：
通过STM32的spi接口读取陀螺数据和加计数据，并对寄存器数据进行温补(Through the SPI interface of STM32, the data of gyro and add-on are read, and the data of register are compensated)
-
-
1下载：
STM32 模拟 SPI 接口 程序默认配置为4线或2线传感器连接方式(STM32 analog SPI interface program is configured as 4-wire or 2-wire sensor connection mode by default)
-
