搜索资源列表
-
0下载：
想学AVR的同学进来吧，好东东哦，你需要准备好如下的软、硬件
1. WinAVR 20050214 版本
2. AVR Studio 4.12
3. STK500 下载(烧录器)器
4. ATmega16 芯片及常用零件若干
-
-
0下载：
ATmega16的定时中断汇编程序，每秒数码管减一，AVR studio环境下用汇编语言编写。-ATmega16 interrupt the regular compilation of procedures, by a second digital tube, AVR studio environment prepared using assembly language.
-
-
0下载：
AD9850串行驱动，ATMEGA16+AVR Studio开发实现-AD9850 serial driver, ATMEGA16+ AVR Studio development to achieve
-
-
0下载：
atmega16驱动四相步进电机，avr studio编译环境，实现电机正转反转，加速减速，上限位、下限位功能-atmega16 four-phase stepper motor driver, avr studio compiler environment, the realization of the electrical switch is turned around, to speed up slow down, the ceiling, and the minimum bit func
-
-
0下载：
atmega16 twi(iic)接口发送数据到AT24C32,再从AT24C32读出数据，并用读出的数据点亮LED灯，用AVR studio编写-atmega16 communicate with AT24C32 through twi(iic) bus
-
-
0下载：
通过winavr+AVR Studio编程，实现了两个Atmega16单片机的RS232通信。包括矩阵键盘检测与LED动态显示。-By winavr+ AVR Studio programming, two Atmega16 MCU RS232 communication. Including the detection and LED matrix dynamic keyboard display.
-
-
0下载：
writng in EEPROM and reading the data for the memory using AVR Studio 4 and controller ATmega16
-
-
0下载：
用ATmega16解码NEC IR协议的源程序，用串口输出到超级终端，这是一份基于中断的，一会上传不用io中断的。开发IDE: AVR Studio-NEC IR protocol with ATmega16 decodes the source, with a serial output to HyperTerminal, which is based on an interrupt, an interrupt will be uploaded without io. Development
-
-
0下载：
用ATmega16解码NEC IR协议的源程序，用串口输出到超级终端，这是一份不用io中断的。开发IDE: AVR Studio-NEC IR protocol with ATmega16 decodes the source, with a serial output to HyperTerminal, this is a no io interrupt. Development IDE: AVR Studio
-
-
0下载：
通过Atmega16单片机调试FC双排15针游戏手柄的c语言程序，开发环境为icc-avr及avr-studio-FC Atmega16 microcontroller debugging through 15-pin game controller double c-language program development environment for the icc-avr and avr-studio
-
-
0下载：
编译为ICC AVR6.25A，仿真为AVR Studio4.10
硬件：ATMEGA16芯片
红外遥控器数码管显示-Compiled for the ICC AVR6.25A, simulation for the AVR Studio4.10 Hardware: ATMEGA16 chip digital display Infrared remote control
-
-
0下载：
This source code how to make running LED using Atmega16 on avr studio 4-This is source code how to make running LED using Atmega16 on avr studio 4
-
-
0下载：
Source Code to practice Interrupt in ATmega16 using AVR Studio 4 and programming C
-
-
0下载：
avr studio环境实现的中断操作，ATMEGA16单片机，led1602显示-avr studio environment to achieve interruption of operation, ATMEGA16 microcontroller, led1602 display
-
-
0下载：
ATMEGA16 comtroller with 4 7segment display, lamp, button, and termomiter (code in AVR Studio 5 + board design)-ATMEGA16 comtroller with 4 7segment display, lamp, button, and termomiter (code in AVR Studio 5 + board design)
-
-
0下载：
基于Atmega16的直流电机驱动程序，用AVR Studio编的-Atmega16 DC-motor
-
-
0下载：
Ａｔｍｅｇａ１６的中断服务程序，基于ＡＶＲ Ｓｔｕｄｉｏ开发的-The Atmega16 interrupt service routine, developed based on the AVR Studio
-
-
0下载：
giving an input output is dispalyed on lcd..implimented using AVR studio 4..controller ATmega16
-
-
0下载：
信号发生器
关键词：ATmega16、LCD12864、ICC AVR、AVR Studio、Proteus、AD5310、UA741、SPI
用ATmega16单片机控制AD5310产生正弦波、方波、锯齿波、三角波信号。通过按键可以切换信号类型、改变信号幅度和频率。
-Signal generator
Keywords: ATmega16, LCD12864 ICC AVR, AVR Studio Proteus, AD5310, UA741, SPI,
ATmega16
-
-
0下载：
编译环境：WINAVR + AVR STUDIO
芯片： ATMEGA16
功能： 定时器、计数器中断 PWM中断 AD采集中断
-Compile environment: WINAVR+ AVR STUDIO
Chip: ATMEGA16
Functions: timer, timer interrupt PWM interrupt AD interrupt
-
