搜索资源列表
LED灯闪烁
- LED跑马灯测试时钟
hfrkLEDtest
- 恒丰锐科44b0 LED灯测试程序，无操作系统测试，C语言。-Prudential Rui Section 44b0 LED lamp test procedure, no operating system, testing, C language.
LED
- 笔记本测试LED灯性能测试，宏基笔记本LED测试-LED light performance notebook test test test Acer notebook LED
LEDTest
- msp430 led灯测试程序。灯有三个，分别是红绿蓝三色，每次点亮一个，然后熄灭。最后三个全亮，全灭。-msp430 led lamp test program. There are three lights, red, green and blue respectively, each lit one, then off. The last three full light, Quanmie.
XL24L01-led
- 这是基于51单片机的NRF24L01的按键和led灯测试程序，代码我已经验证过。 供大家学习用，只要修改下代码就可以应用到其他的单片机。这个程序是一个半双工的通信模式.含有电路原理图-This is based on MCU 51 NRF24L01 the button and led lights test program, the code I have already verified. For them to learn to use, as long as the changes ca
LED_XS128
- 飞思卡尔led灯，闪烁测试程序，用C语言编写-Freescale led lights，Flashing testing procedures, written in C
ledtest
- MSP430G2553,LED灯测试程序，用于控制流水灯得实现-MSP430G2553, LED lamp test procedure was used to control the lights to achieve water
LED
- C8051F930 LED灯显示程序用来实现简单的单片机测试-C8051F930 LED
led
- led灯模拟电梯走法 经测试可运行，无按键锁存功能-A led game like a floor.
led
- 基于51单片机实验板设计原理图及led灯测试c代码-Based on 51 single-chip board design schematics and led light test c code
Ledtest
- 博创科技开发板基于S3C2410的LED灯测试程序-a led test soft in EVC
LED
- 基于TC35i的远程温度报警系统设计中，硬件电路上的LED灯测试程序，也是基于C51编写的，验证过-TC35i based on the remote temperature alarm system design, hardware circuit LED lights test program, which is also based on C51 preparation, and validated
led-P0~P4
- stc单片机测试源程序,此程序用于点亮P1至P4口的LED灯。-STC Single-chip test source .
GPIO
- IO口测试程序 轮流置高和低，可接LED灯测试或用万用表测试，或单独设定电平值-IO port test program Rotation values of high and low, the LED lamp test with a multimeter to test which can be accessed or a separate set of level values
GPIO
- 轮流置MSP430的高和低，可接LED灯测试或用万用表测试，或单独设定电平值-Take turns to buy MSP430 with high and low, may meet LED lamp test or using a multimeter to testing, or separate set level value
LED
- 功能：点亮P0口的1个LED灯并闪烁 适用于初学者，以及测试单片机好坏-Function: lit P0 port LED lights and a flashing
LED
- Aduc845的入门测试程序，点亮LED灯，不停闪烁。-Aduc845 entry test program, turn on the LED lights flashing.
1.GPIO实验-控制Led亮灭
- Led灯的zigbee驱动程序，已验证，属于出厂测试程序(The zigbee driver for Led lights has been verified and belongs to the factory test program)
led测试程序（调试通过）
- led测试程序，led灯基础点亮！stm32(LED test program, LED light foundation lighting! Stm32)
实验3：LED流水灯
- LED流水灯PWM PWM调光程序,可以实现led灯渐变的效果用于STC89C52 上测试通过。(LEDLED water lamp PWM PWM dimming program, can achieve LED lamp gradual effect, for STC89C52 test pass.)