搜索资源列表
uCOS-II--149
- 参考网上的提供的代码,我把uCosII移植到MSP430f149上,分三个任务,分别是485通讯,键盘扫描,LED显示,可供参考!-online reference provided by the code, and I uCosII MSP430f149 transplant, in three tasks, namely, 485, keyboard scan, LED display, for example!
Glcd
- 是门禁LED显示程序，其中有许多函数接口程序非常实用，一个不错的程序-is seldom LED display program, many of which function interface procedures are very practical, a good procedure
s3c44b0ledxianshi
- /*** *** *** *** *** *** **/ //**此映射表用来映射LED模块不译码时，显示的字符和必须输入的数据的关系 //**每段和对应比特位的关系见示意图 // g // --- --- // b | a |f | | <---显示0时点亮的段为gfedcb // --- // c | |e | | 那么写入数据为0x7e // --- --- //
LJD-44B0XDVK_uCOS276
- 基于44B0的uCOS程序，包括Led显示等周期闪烁，按键输入，定时中断，打印log，初学者可用此入门-44B0 for uCOS procedures, including Led blinking cycle display, keypad input, timer interrupt, Print log, the portal available to beginners
uCOS-II--149
- 参考网上的提供的代码,我把uCosII移植到MSP430f149上,分三个任务,分别是485通讯,键盘扫描,LED显示,可供参考!- Refers to code which on-line provides, I transplant uCosII to MSP430f149 on, divides three duties, respectively is 485 communications, scanning, LED demonstrated
uCOS-II_LED
- 基于uCOS-II嵌入式操作系统的LED显示功能的源程序
SingUCOS
- UcosII在freescale单片机上的移植例子 包含ad，七段码显示，LED等任务
startup
- 开发环境是ADS 1。2 键盘和LED显示
osled2
- 完成在S3C2410处理器上移植μC/OS-II内核，然后实现以下多任务： a) 控制实验箱核心板上4盏LED灯轮流亮灭； b) 将LED1连接到ARM9-2410EP增强型实验箱扩展口的DA OUT端口，通过实验箱上的键盘（比如“↑”、“↓”键）控制LED1亮暗变化，同时在超级终端显示该控制值； c) 将LED2连接到扩展口的I/O输出口，通过超级终端按键控制LED2亮灭，即按一下PC的超级终端某个键（比如回车键）LED2灭，再按LED2亮，反复循环。
uCOS-II
- UCOSII在51单片机上的移植，有LED显示实验等，已测试通过。
Exp1-Led
- 44B0 的LED显示程序不带UCOS操作系统-44B0 LED display program operating system without UCOS
ucos_led
- 基于ucos的7段式led显示程序。可以方便的移植到不同的平台。能够任意位置显示。-Based on the 7-piece ucos display program led. Can be easily ported to different platforms. Be able to show anywhere.
uCOS_C51_LED
- uc-os在单片机上的移植，keilc中运行通过，LED显示-uc-os transplantation in the single-chip, keilc run through, LED display
uCos2_1029B
- 基于S3C2440的开发，移植有UCOS，带液晶显示3.5寸液晶，实时时钟和ADC采样，led显示等。-Based on the development of S3C2440 UCOS, belt, transplanted with 3.5 inch LCD LCD display, real-time clock and ADC sampling, the led display.
ucosCeshi
- 基于ucos系统的压力测试系统（有键盘，led显示，报警等功能）-Ucos system pressure test on the system (with the keyboard, led display, alarm and other functions)
uCos2-6410-player(20140221)
- 在ok6410开发板移植了uc/osII操作系统，并用PWM定时器实现了蜂鸣器播放乐谱及led显示的功能，所有代码均已调试成功。-In ok6410 development board transplant uc/osII operating system, and with the PWM timer function to achieve the buzzer to play the score and led display, all of the code have been succe
STM32C8T6-PIANO-ucos
- UCOSII工程的MIDI解析 解析MIDI内容，根据MIDI文件内的节拍和音符进行钢琴教学的指示 发送到DM132进行LED显示，显示MIDI的键位和力度 内含对应到钢琴键位的原理图，和所用DM132的规格书-MIDI analysis of UCOSII project MIDI content analysis, according to the rhythm and notes in the MIDI file to carry out the instruction o
uCOSII_v2.91
- 代码是在STM32上移植的ucosII，ucos版本号为2.91。移植后有简单LED显示，可作为ucos研究的模板使用。-Code is on the STM32 transplant ucos II, ucos version number is 2.91. After transplantation simple LED display can be used as a template to use ucos research.
SteppingMotor_PWM_Adc_DMA(S加速_开漏输出)
- 具有按键、LED显示、ADC等功能，采用PWM控制步进电机(With buttons, LED display, ADC and other functions, the use of PWM stepper motor contro)
LED
- 花式流水灯的显示，可通过修改完成不同的灯型(The display of fancy water lamp can be finished by modifying different lamp types)