搜索资源列表
fpgaandmcuand25h20.rar
- FPGA 和MCU的并口通信 及MCU和E2PROM(FM25H20)SPI通信 功能:FPGA对MCU的写(FPGA发给MCU的地址是写进E2PROM的地址 ,E2PROM中的数据是 FPGA发送的数据。) FPGA对MCU的读(FPGA读取它发给MCU在E2PROM中存取的数据) 程序和图见附件 恳请高手指导 小弟急啊!,FPGA and MCU
shibo(ok).rar
- 基于cycloneII和MSP430单片机的示波器,利用spi模块进行双机通信,Based on the MSP430 MCU and cycloneII oscilloscope, using dual-spi communication module
SPI
- VHDL语言编写的SPI通信接口,可实现与单片机等外部MCU的通信,且只占用较少的引脚线-Written in VHDL SPI communication interface, can be realized with the microcontroller and other external MCU communication, and only takes less pin line
MCU_FPGA
- 利用FPGA模拟SPI总线,可以与其他器件通信,比如MCU-FPGA simulation using SPI bus, you can communicate with other devices, such as the MCU
FPGA_SPI_Trans
- FPGA模拟SPI与MSP430通讯Verilog程序-A verilog program of fpga talks to mcu msp430 using spi
80C51_1
- 1.异步通信软件模拟2.基于RS-232的串口通信3.基于RS-485的多机通信4. I2C总线协议的软件实现5. SPI总线在单片机系统中的实现6.-wire-1. Asynchronous communication software simulation 2. Based on the RS-232 serial communication 3. Based on the RS-485 Multi-machine communication 4. I2C bus protocol soft
8bit_switch
- 用verilog实现按键扫描,并把按键扫描结果以类SPI的方式传给单片机。-Verilog implementation with key scan, and the key results of the scan the way to class to pass SPI MCU.
interface
- 单片机接口实用程序,包括I2C,SPI总线的程序,各程序均已调试成功。-MCU interface utilities, including I2C, SPI bus, the procedures, the procedures are debugging success.
LPC900_SPI
- LPC900 FLASH单片机,是PHILIPS公司推出的一款高性能、微功耗51内核单片机,主要集成了字节方式的I2C总线、SPI总线、增强型UART接口、实时时钟、E2PROM、A/D转换器、ISP/IAP在线编程和远程编程方式等一系列有特色的功能部件。-LPC900 FLASH MCU is PHILIPS company introduced a high performance, micro-power 51-core chip, a byte-oriented major integr
FPGA_SPI_VHDL
- 串行外设接口(SPI)fpga 被动接收,在下降沿 采集数据并发送数据 1BYTE,要求mcu在末端采集数据。并在下降沿之前准备好数据。-Serial Peripheral Interface (SPI), The fpga passive receiving, at the falling edge of data collection the send data 1BYTE, mcu data collected at the end. And the data ready before t
aw60-SPI(AT45)_C
- 此为aw60单片机 实现spi通讯的两类代码 中断以及查询发送 -This interruption for aw60 MCU sci communication of the two types of code, and send a query
Verilog-SPI
- 用FPGA实现SPI通讯,使用VerilogHDL语言编写,附相对应的MCU端时钟配置注意事项-Using FPGA implements SPI communication, Code use VerilogHDL language, attached corresponding to the MCU side clock configuration Note
SPI-desgn.zip
- 同步串行外设接口,它可以使MCU与各种外围设备以串行方式进行通信以交换信息。传输的数据为8位,在主器件产生的从器件使能信号和移位脉冲下,按位传输,高位在前,低位在后。,Synchronous serial peripheral interface, it can make the MCU with a variety of peripheral devices to communicate in order to exchange information in a serial manner.
SPI_FPGA_WITH_MCU
- MCU与FPGA之间实现SPI通信,包括底层的设置,按键的控制等。-SPI communication between the MCU and FPGA, including the underlying set button control.
MCU2FPGA_SPI_TB
- 本程序使用Verilog语言实现了SPI接口的设计,可以直接烧到FPGA实现与MCU的通信,自带有测试文件。-The program uses the Verilog language design SPI interface, you can burn directly communicate with the FPGA, MCU, comes with a test file.
Test_96_Right2
- MCU配合FPGA控制驱动96路电机,其中MCU与FPGA间用SPI通信,本文件为FPGA部分verilog源程序-MCU with FPGA control and drive motors ,where MCU communicate with FPGA using SPI
SPI_Interface
- This module implements Serial Pheripheral Interface(SPI) Slave logic. It Communicates with MCU(Master).SPI Mode CPOL = 0 CPHA = 0 Serial Clock frequency MCU is 1 MHz. For SPI Mode CPOL = 0 CPHA = 0 -This module implements Serial Pheripheral Inte
SPI总线
- 串行外设接口 <SPI>模块是一个同步串行接口,可用于与其他外设或者单片机进行通信。这些外设可以是串行EEPROM、移位寄存器、显示驱动器和A/D转换器等。SPI模块与Motorola的SPI和STOP接口兼容。(The serial peripheral interface <SPI> module is a synchronous serial interface, which can be used to communicate with other periph
UC1676C
- 51单片机测试程序,IC:UC1676,4线串口(51 MCU test program, IC:UC1676 4-LINE, SPI INTERFACE)