搜索资源列表
snr_serMatlab
- 数字通信系统中采用基带传输和频带传输[ 1, 2 ] ,在抽样判决器之前,信号叠加了信道噪声. 本文利用 Matlab软件仿真[ 3, 4 ]分析了在判决器前叠加了高斯噪声后,信噪比与系统的误码率之间的关系.-Digital communication system using baseband transmission and band transmission [1, 2], in a sample before the decision device, the signal super
adaptiveOFDM
- 本程序利用改进的CHOW算法，仿真了自适应OFDM系统的性能，并画出了SNR-BER仿真图。对于学习OFDM自适应资源分配者有很帮助。-This procedure improved CHOW algorithms, simulation of the adaptive OFDM system performance, and draw the SNR-BER simulation Fig. Adaptive OFDM for learning the distribution of resou
Matlab
- 很好的OFDM的基于MATLAB的仿真程序包，且包含了最终结果图.-montecarlo type montecarlo in the command window and wait for a long time.. _simulation of the complete OFDM system. _use of a very large file in order to get probabilities. _loop over different valu
bersnrrayleigh
- ber vs snr for awgn-rayleigh channel
SingleCellofdm
- OFDM链路级的仿真器场景是单小区单用户，信号从发送端发送，在接收端进行信号估计。估计误差可以从接收和发送信号的不同得到。仿真器的输出是BLER/BER vs SNR。-OFDM Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx si
AWGNchannelBPSKmod
- The simplest channel which we use in ideal case is AWGN channel and everyone knows that before starting siluation on the other part of the system we must simulate the AWGN channel.this is AWGN channel with a BPSK signal going through it and finally w
spacetime_hdogan
- Program for Space-Time-Block-Code BPSK modulation performance as a function of SNR and BER. (MATLAB)
thesissim
- this a matlab code for cdma it is a calculation of ber,snr etc. -this is a matlab code for cdma it is a calculation of ber,snr etc.
16QAM_Bit_Error_Rate_(BER)_with_Gray_mapping
- 仿真分析在格雷码和QAM调制下的SNR与BER关系-analyze gray code and QAM moudulation about SNR and BER relationship
BPSK_generation
- It is BER vs SNR codes for BPSK and 4QAM
sim_qpskgray_multipath
- QPSk MOdulation SNR and BER
Application-of-modulation-scheme-according-to-SNR
- The report describes various modulation schemes and the SNR and BER Performance of the schemes. The project is about a program that selects a particular modulation scheme according to the SNR and BER performance required.
AF_ro
- amplify and farward : code in mtalab that produce figures of BER and SNR for amplify and farxard relay
lms-rls-mlse
- THis transceiver system simulation to display ber vs SNR. TRansceiver is about BER comparison between LMS-RLS and MLSE receiver to invers the rayleigh fading channel. The content of system is modulation, pilot adder, awgn and rayleigh fading channel,
PAPR-Reduction2
- This M Code simulate the effects of clipping and filtering on PAPR reduction in OFDM-based wireless standard.Also the performance of BER versus SNR of original OFDM signals with PAPR reduction based on clipping and filtering schemes over AWGN channel
Link-a-System-Level-OFDM-Simulator
- 针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。-It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and
AF-cooperative-diversity-Matlab-code
- This program stimulation AF cooperative diversity with matlabcode and earn SNR versus BER-This program stimulation AF cooperative diversity with matlabcode and earn SNR versus BER
MIMO-final-WTF
- Calculating SNR and BER to System MIMO using SVD and receiver shaping.
code-matlab
- 利用SIMULINK和M函数相结合的方式仿真BFSK 调制在多路径瑞丽衰落信道中的传输性能。其中 source产生速率为10Kbit/s、帧长度为1秒的二进制数据源data,并且通过BFSK产生调制信号。BFSK调制的频率间隔为24KHz, BPSK调制符号的样点数为2，调制信号通过多径瑞利衰落信道，移动终端相对运动速率为40公里/小时，接收端对信号进行解调，并把解调后的信号和原始数据信号相比较计算误比特率。最后Sink模块根据SNR与误比特率的关系绘制曲线。-And M functions u
channel_estim
- 一种信道估计算法，最终给出了信噪比与误码率的关系曲线-A channel estimation algorithm gives the final curve of the SNR and BER.