搜索资源列表
c51源程序库
- C51的程序库，包含了读写卡、LED驱动、4*4键盘扫描等子程序-C51 libraries, which includes a card reader, LED drive, 4 * 4 keyboard scan subroutine
ADC0834
- 串行8位AD采样驱动程序,本程序应用将采样结果驱动8个LED灯-serial eight AD driver, the application process will be results-driven sampling eight LED lights
YIBUPstc9
- LED显示屏驱动程序，接收字母符号汉字的内码，显示到显示屏上。
VB6.0LED
- led点阵驱动的VB6.0和单片机接口程序。
64x64LED.16字 LED点阵屏+DS1302电子钟 C 程序
- 16字 LED点阵屏+DS1302电子钟 C 程序 1 脚接+5V 2，3脚32768HZ晶振 4脚接地 5脚接S51的P02 6脚接S51的P01 7接S51的P00 8脚接后备电源，可以接老计算机主板上的3.6V电池，也可以通过二级管隔离接一个大容量电解电容 电压在2.5V以上即可维持 595连级输出数据，138行驱动 P1_0为时钟模式转换键、P2_1为时钟加键、P1_2为时钟减键、P2_3为时钟复位键。在对时钟调整时未对调整 项做闪烁处理,16-chara
46R47_1606_LED.rar
- 一个用HT46R47驱动HL1606控制的LED软灯条程序,HL1606 drive with HT46R47 a control procedure LED soft light
EM78P153S-LED
- 程序用EM78P153S对2个74HC4094的控制，驱动segment led 及led 灯。-Procedures used EM78P153S of two 74HC4094 control, drive segment led and led lights.
C8051F330_LED
- 该程序用SLAB公司的c8051f330单片机来实现LED灯的驱动，使其闪烁-this programme uses c8051f330 to lite LED
led20
- 一个8051程序，LED灯柱显示，用164驱动，并且灯柱不闪。-LED lamp post indicates that with 164 drivers.
c51
- 74hc595的c51驱动程序,led大屏幕显示系统-74hc595 of c51 driver
LED
- LED驱动程序,一个8乘8的LED显示驱动程序-LED Driver
lab3
- 编写程序，将开关的状态读入计算机，并将它通过输出端口驱动发光二级管显示相应的状态。 输入端口74LS244和输出端口74ALS273的地址均为6460H。 -Write a program that will switch the state to read into the computer, and output ports drive LED display the corresponding status. The address of the input port 74L
OHSEI-BMS
- 4.3寸led驱动程序，对24只电池进行监控和管理，自动平衡。-4.3-inch led driver, 24 battery monitoring and management, self-balancing.
DS_PIC16F883_Led_Panel_74ls164
- PIC16F883使用74ls164驱动LED数码管的程序，使用3个脚可以控制8个LED数码管的显示，同时将TRC芯片ds12887的时钟内容显示出来-The PIC16F883 to use 74ls164 drive LED digital tube procedure, the use of 3 feet can control of eight LED digital tube display, at the same time the the TRC chip clock ds1288
Output-LED-Control
- 项目测试结束时都会有结果显示，除了在程序界面上显示外，同时也在硬件上显示。本子程序除了在程序界面上显示外，硬件上用12条IO数字线控制74HC373驱动LED显示，LED用的是共阴极双色（红色和绿色）指示灯，同时附上原理图，-The end of the project testing results show that, in addition to displayed in the program interface, as well as the hardware on display.
vcr_LED-IR_VCR
- LED灯带基于lua开发的驱动程序。经过测试，十分好用。-LED lights with lua-based development driver. After testing, very easy to use.
T10
- 8279驱动LED显示,单片机接口电路驱动程序，经典程序-8279 LED display driver
STM8(LED)
- stm8系列单片机 IO驱动数码管基础c语言程序-STM8 io basic software
[SMG_Dynamic-display]
- 基于STM32F103的6位数码管动态显示驱动程序-STM32F103 based on the 6 digital LED dynamic display driver
EB001
- LED驱动板ED控制 单键控制LED程序,按一下按键,灯打开,电流为700MA，5分钟后，电流降为260MA，再20分钟后，电流降为130MA； 再按一下按键,电流持续130MA; 再按一下按键灯关闭(LED drive board ED drive board ED control Single key control LED program, press a button, the light is open, the curr