搜索资源列表
DFA_for_linux
- 随机信号处理Detrended Fluctuation Analysis方法的应用程序，采用c实现，linux环境，带makefile。-random signal processing Detrended Fluctuation Analysis of applications, using c realized, linux environment, with makefile.
CP0303_PPM_RANDOM
- 随机调制信号下的模拟ppm的matlab仿真-random modulation signal simulation ppm of Matlab simulation
Fundamentals_of_Statistical_Signal_Processing
- 《Fundamentals of Statistical Signal Processing》（《随机信号处理基础》）的配套MATLAB源代码。为电信工程师、教师、和学生而设计。-"Fundamentals of Statistical Signal Proc essing "(" Random signal processing based ") supporting MATLAB code. To the telecommunication engin
ARestimate
- 基于自回归,全极点的AR模型,对随机信号的进行的功率谱估计.-based on the return of all Poles AR model of random signal of the power spectrum estimation.
signal
- 产生编码解码时使用的clk_1以及频率为它31倍的clk_31信号。 //产生M序列的发送信号indata(随机),并且将接收到的解码信号（decode）进行比较。 //发送的头10个信号为1，第11个为0，在解码的开始时期进行同步判断时用到。-Have used codec clk_1 as well as the frequency of 31 times it clk_31 signal.// Generate the M sequence signal indata (rando
random-binary
- 数字调制器的墓本构建模块是函数random-binary，它产生电平值为+1或一1的二进制波形，产生的比特数以及每比 特的采样数是该函数的参数。函数random-binary可以仿真多个数字调制器，例如，可用如下MATLAB语句仿真一个QPSK调制器: 下列MATLAB程序产生一个长10比特的QPSK信号,采样频率为每比特8个采样点: -Digital modulator building blocks of the tomb is a function of the random
Labview
- 虚拟仪器Labview：FFT、采样、加窗、互相关分析仪、滤波器、谱分析、随机信号分析仪、信号发生器.exe自谱与自相关分析.exe的可执行程序-FFT, sampling, windowing, cross-correlation analysis instrument, filter, spectrum analysis, the random signal analyzer, signal generator exe autospectrum autocorrelation analysi
gonglvpu
- 随机信号功率谱估计，在频域对信号进行分析，用Matlab编程-Random signal power spectrum estimation using Matlab programming
nonstationary-random-signal-WVD
- 此例程为配套书籍的第六章例题6-5的相对应代码，功能为计算非平稳随机信号的WVD时频谱，编程环境为matlab。-This routine matching books Chapter Example 6-5 corresponding to the code for the calculation of the non-stationary random signal WVD spectrum programming environment for matlab.
signal-enhancement-in-the-noise-
- 在噪声环境下语音信号的增强 语音信号为读入的声音文件 噪声为正态随机噪声-Speech signal in the noise environment of the enhanced speech signal into a sound file for the read noise of the normal random noise
signal-acquisition
- 利用随机数发生器仿真一个0到5V的采样信号，每200ms采一个点，共采集50个点，再增加1路电压信号采集，此路电压信号的范围为5到10V，采样间隔是50ms，共采100个点，采集完后一次性显示在Waveform Graph上。-Simulation using a random number generator with a 0 to 5V signal sampled every 200ms adopt a point of collecting 50 points, and then add
MATLABGUI
- 信号处理与分析，是基于gui的信号处理与分析，相关函数的应用。-Random signal analysis and Process
LABVIEW00
- 基于声卡的数据采集,先是采集时域信号后面做频谱分析最后物理计算，使用时用伪随机信号测量为好。-Data collection based on the sound card, the first is the acquisition time domain signal behind spectrum calculation finally physical analysis, when used with a pseudo random signal as well.
DSP_3_17_2
- 产生随机信号观测样本，不同信噪比和归一化频率。分别用BT法和周期图法估计功率谱密度。-Generate random signal observation samples, different signal to noise ratio and normalized frequency.Using method of BT and cycle diagram method to estimate the power spectral density.
shengchengxinghao
- 产生随机信号。此模块是用于评估当信号中有谐波时，对电能质量产生的影响-Generate random signal.This module is used to assess when a harmonic signal, the influence on power quality
MATLAB-simulink-communication(up)
- MATLAB通信基础，SIMULINK仿真基础、离散信号随机信号、低通带通、高斯白噪声信道、多径衰落信道、幅度调制、角度调制、正交信号传输特性、二进制基带信号的最佳接收等。-Communication based on MATLAB and SIMULINK simulation, random signal, discrete signal to a low-pass bandpass, white gaussian noise channel, multipath fading channe
Random-noise-Synthetic-Aperture-Radar
- Random noise Synthetic Aperture Radar simulation of point target where the transitted signal is Gaussian
wvd
- 魏格纳时频分布，非平稳随机信号离散时间wvd仿真处理-Wigner time-frequency distribution, non-stationary random signal processing discrete-time simulation wvd
yiweixinhao_OMP
- 压缩感知中关于OMP算法的重构算法，主要针对一维随机信号-The reconstruction algorithm of OMP algorithm in compression perception is mainly for one- dimensional random signal
SY5_4
- 将一组随机信号数据加上时间标记存储为数据记录文件，然后将存储的数据读出 并显示在前面板上。(A set of random signal data is added to a time stamp to store data records, and then the stored data is read out. And display on the front panel.)