MCS-96单片机要用PWM产生锯齿波，应使PWM寄存器中的值线性增加，那么在PWM输出端将得到宽度线性增加的脉冲波，经滤波后，便可得到锯齿波。-MCS-96 microcontroller with PWM have Sawtooth, PWM register should be the value of linear increase, then the PWM output will be increased linearly width of the pulse wave, After

51单片机与0832波形发生器锯齿波、三角波、正弦波-51 single-chip microcomputer and 0832 waveform generator sawtooth wave, triangle wave, sine wave

基于单片机的波形发生器，产生矩形波，正玄波，三角波，锯齿波和方波-Microcontroller-based waveform generator generates a square wave, sine wave, triangle wave, sawtooth and square wave

基于51单片机的信号发生器（方波、正弦波、三角波、锯齿波）-Based on 51 MCU signal generator (sine, triangle, sawtooth, square wave)

利用0832同步输出两个频率为50赫兹的锯齿波（硬件电路参见DA_BUF2_1.DSN）。(Using 0832 simultaneous outputs, two sawtooth waves with frequencies of 50 Hz (hardware circuit refer to DA_BUF2_1.DSN) are used.)