搜索资源列表
MATLAB-PISM
- 这是显示通信系统中两路信道内噪声相关系数大小，如何确定，受什么参数影响的函数表达-communication system both within the channel noise correlation coefficient size, how to identify, affected by the parameters of function expression
LTE 下行链路完整链路级仿真matlab代码
- 下行链路完整链路级仿真matlab代码 包括pdsch，pdcch，phich，pcfich等。
IS95前向链路系统
- 这是IS95前向链路系统的MATLAB仿真程序及仿真结果，仿真环境为加性高斯白噪声信道。
Matlab_ica.该算法实现了两路语音的分离
- 该算法实现了两路语音的分离。主要为fastica算法的matlab实现。,The algorithm achieved a separation of two-way voice. Mainly to achieve fastica algorithm matlab.
WCDMAsim.rar
- WCDMA链路仿真，包括源代码与相关文档资料。,WCDMA Link Simulation, including source code and related documentation.
最小费用最大流算法通用Matlab程序
- 基本思路：把各条弧上单位流量的费用看成某种长度,用Floyd求最短路的方法确定一条 ％ 自V1至Vn的最短路 再将这条最短路作为可扩充路,用求解最大流问题的方法将其上的流 ％ 量增至最大可能值 而这条最短路上的流量增加后,其上各条弧的单位流量的费用要重新 ％ 确定,如此多次迭代,最终得到最小费用最大流.,Basic ideas: to each arc on the unit cost of traffic as some length, with Floyd for the most shor
LTE.rar
- LTE的链路仿真,很有借鉴意义，你们可以参考一下,simulink model for LTE link
TD-SCDMA的链路级仿真过程源代码分析
- TD-SCDMA的链路级仿真过程源代码分析，QPSK调制，维特比译码-TD-SCDMA link-level simulation analysis of source code, QPSK modulation, Viterbi decoding
daolujianmo
- 基于人工势场的MATLAB道路建模及车辆避障-MATLAB based on artificial potential field of road traffic modeling and obstacle avoidance
CFA-Matlab
- 有关链路容量和流量优化分配的遗传算法 函数功能 使用遗传算法求解通信网链路容量和流量联合优化分配问题-Related to link capacity and flow of genetic algorithm to optimize the distribution function using genetic algorithm function communication network link capacity and traffic distribution of the
VisionGuidedVehicleRoadIdentification
- 视觉引导车路识别：灰度AGV路径识别；彩色AGV路径识别；HSI彩色空间的AGV路径识别；路径中心线的定位；Radon变换的AGV路径偏差检测-Vision Guided Vehicle Road Identification: gray AGV path identification color AGV path identification HSI color space of the AGV path identification path centerline positionin
Matlab
- 选择三个不同频段的信号对其进行频谱分析，根据信号的频谱特征设计三个不同的数字滤波器，将三路信号合成一路信号，分析合成信号的时域和频域特点，然后将合成信号分别通过设计好的三个数字滤波器，分离出原来的三路信号，分析得到的三路信号的时域波形和频谱，与原始信号进行比较，说明频分复用的特点。-Choice of three different signal-band spectral analysis carried out, according to the characteristics of the
4
- 道路中心线的检测，基于matlab实验，包括源码，实验图片-Detection of the road centerline, matlab-based experiments, including source code, experimental picture
UWB-MATLAB
- 分别展示了PPM-TH-UWB系统的整个发射链路，PAM-DS-UWB系统的发射链路和MB-UWB信号的产生。-Were demonstrated PPM-TH-UWB system links the entire launch, PAM-DS-UWB systems transmit chain and MB-UWB signal.
Matlab
- 蚁群算法最短路径通用Matlab程序蚁群算法动态寻路算法-Shortest path algorithm for general ant colony algorithm Matlab program Dynamic Algorithm for Route
matlab-codes-source
- 无线通信物理层信道建模，链路衰落，LDPC编码，OFDM，及智能天线等等关于物理层的码源-Wireless communication channel modeling the physical layer, link the decline, LDPC codes, OFDM, and smart antennas, and so the source code on the physical layer
IS95前向链路系统
- IS95前向链路系统:此函数用于IS-95前向链路系统的仿真，包括扩频调制，匹配滤波，RAKE接收等相关通信模块。 仿真环境: 加性高斯白噪声信道.(IS95 forward link system: this function is used for the simulation of IS-95 forward link system, including spread spectrum modulation, matched filtering, RAKE reception and
多路相关器的并用
- 该程序为比相法测频技术中多路相关器的并用实验，与书上仿真结果吻合(The program is a combined experiment of multichannel correlator in the phase comparison frequency measurement technology, which is consistent with the simulation results in the book)
-MATLAB-802.11a--master
- 使用MATLAB对802.11a协议进行链路仿真。(Use MATLAB to simulate the link of the 802.11a protocol.)
汽车悬挂设计matlab
- 1.被动悬挂设计simulink模型 2.对于任意一段路面谱，求出其功率谱密度与频率的分布关系，在标准路面图中画出曲线验证路面 3.积分白噪声法路面构造simulink模型 4.整车平顺性分析simulink模型 5.实际路谱案例，c级路面 6.悬架动载荷功率谱密度图像画图matlab编程(1. Simulink model for passive suspension design 2. For any section of road spectrum, the