搜索资源列表
basic.zip
- 飞思卡尔MPC5554 target To build your project, use the menu Project > Make or press F7. This will build the selected target.,This is release 1.00 of the eTPU function set1. The package contains the binary image of the eTPU code for the CPU to use,
sprom
- 430单片机自升级程序，这段程序已经成功应用，可以直接使用，换单片机后须重新设定串口和缓冲区-Singlechip 430 since the upgrade process, this procedure has been successfully applied, can be directly used for single-chip to be re-set after the serial port and buffer zones
uart_rt
- stm8的uart的收发例程，利用中断，将接收的字符，重新发出去-stm8 the uart to send and receive routines, the use of interrupts, will receive the characters, re-issued to
uart_regs
- 串行通讯ip核，经过仿真验证，综合，可以参考使用-Serial communication ip nuclear, through simulation, synthesis, can refer to the use of
AVRcCode
- 本程序是运行于AVR单片机ATmel128上的数据采集程序，并实现了基于uart的数据通信功能。可供学习开发AVR单片机程序的人员研究和再次开发-This procedure is running on the AVR Single Chip Data Acquisition ATmel128 procedures, and to achieve uart-based data communication functions. AVR for single-chip development to
UART
- （1）在FPGA上设计UART接收模块实现从PC接收串口数据(RS232串口通信)； （2）在FPGA上设计UART发送模块，把从PC接收的数据的16进制值加1再发送给PC； -(1) Design UART receiver module receives serial data (RS232 serial communication) the PC to the FPGA (2) Design UART transmit module on FPGA, the hexadecim
UART
- 在DE2开发板上实现串口收发设计，系统时钟频率为50MHz,reset信号低电平有效，输入数据最高位为1时按位取反再输出-Achieve serial transceiver design DE2 board, the system clock frequency of 50MHz, reset active low signal, the input data is the most significant bit is 1. Bitwise re-export Google 翻译（企业版
URAT
- 在ISE环境下，用VHDL语言实现RS232串口设计，实现串口通信。通过串口调试工具向 0000000UART发送16进制数，FPGA将UART接收到的串行数据转换为并行数据，并在8个 LED灯上输出显示；同时，并行数据又被重新转换为串行数据，重新送给RS-232接口，并在 串口调试工具上再次显示，SW0为复位键。 比如：串口调试工具发送两位16进制数，然后能在LED上显示，并且重新在串口调试工 具上显示。串口调试工具设置：波特率设为9600，默认奇校验。-In the IS