资源列表
bian
- 用C语言编程实现的基于avr单片机的编码程序-Programming with C language-based single-chip encoding procedures avr
singlpid
- 用MATLAB编写的单神经元PID仿真程序,可以在具体控制实例中加以验证-Prepared using MATLAB single neuron PID simulation program, you can control in specific cases to verify the
wendu3
- c8051f020 内部温度传感器 lcd自动显示-c8051f020 internal temperature sensor automatically display lcd
wendukongzhipidsuanfa
- 基于DS18B20的水温控制系统中的PID算法，使用51单片机。-DS18B20 water temperature control system based on the PID algorithm, using 51 single chip.
cc
- wifi智能车c语言程序的编程与应用-wifi smart car c language programming and application procedures. . . . . . .
748734893
- 单片机 通过串行口控制数据的输入输出 例程 请使用keil打开-SCM through a serial port control data input and output routines
ADC7705
- AD7705测试代码，经过实测并实际应用。该文件为c文件，可直接添加进工程，修改引脚定义即可使用。-AD7705 test code, after the measured and practical application. C file, the file can be added directly into the project, modify pin definitions can be used.
PPM-Controler-C51
- 遥控设备使用PPM编码模式驱动舵机，本程序模拟PPM形式对舵机进行检测，可测试舵机偏转。程序对应标准C51单片机。-Remote control devices using PPM encoding mode driver steering, the program simulates the form of servo PPM detects testable steering deflection. Corresponds to the standard procedures C51 mic
DS18B20
- DS18B20 温度检测 读一字 写一字 初始化 读取温度-DS18B20 temper
stepmotor
- 步进电机 正反转 stepmotor 步进电机 正反转 stepmotor-Stepper motor stepper motor stepmotor stepmotor
WDT
- 看门狗应用.本程序系统启动时,LED1点亮,正常运行时,LED1熄灭,LED2开始闪烁程序设置看门狗溢出时间为:1.9s,定时器必须在此时间内复位看门狗(喂狗),否则会引起系统复位,LED1再次点亮后熄灭,LED2重新开始持续闪烁.-Watchdog application of this procedure when the system starts, LED1 lights up during normal operation, LED1 off, LED2 starts flashing
main
- 智能小车循迹程序，L298驱动，两路循迹-Smart car tracking procedure, L298 drive, two path tracking