资源列表
yaoyaobang
- 类似旋转时钟，一手持方式在空中摇动，由于视觉暂留，可以替代点阵的列扫描-Similar to the rotating clock, a hand-held shaking in the air, due to persistence of vision, can replace the matrix of column scanning
motor2
- The motion control is very simple. Adding an incremental position to the position set point on a periodic basis essentially sets the velocity. In the following code I broke out the "AddToPosition" so that Dilbert s wall following and line following c
Motor-control-using-DSP
- DSP code for motor control.
part3.3
- 郭天祥 单片机书 配套c程序 第三部分3 郭天祥 单片机书 配套c程序 第三部分3-the program of guo tianxiang part3-3 the program of guo tianxiang part3-3
shurushuchu
- 51单片机 4x4键盘输入 4位数码管显示程序-51 single-chip 4x4 keyboard input 4 digital tube display program
system
- TMS320F240开发时，使用的CMD文件，配置DSP中的RAM，ROM地址-The TMS320F240 development, use the CMD file, configure the DSP, RAM, ROM address
LCD12864
- 本内容为LCD12864的驱动函数，可以适合刚入手液晶屏的同学学习-The content LCD12864 driver function can fit LCD classmates just start learning
AGC-program
- 有些AGC参考代码可以直接插入到程序调用。 TMS320VC5509A测试-Some AGC reference code can be inserted directly into the program calls. TMSVC5509A test
independent-key
- 在C51单片机中，一些独立按键的驱动程序，可以用来控制其他的芯片-In C51 microcontroller, some independent key driver chips can be used to control other
MCU-at89c52-lantern-controller
- 单片机at89c52彩灯控制器,实现彩灯的控制和点亮-MCU at89c52 lantern controller, to achieve control and lit lanterns
ad
- 用单片机来编程实现关于模拟量和数字量之间转换-MCU to programming on between the analog and digital conversion
timer
- 100000秒以内的计时程序100,000 seconds within a timing program-100,000 seconds within a timing program