资源列表
DYNA3D Code Practices and Developments
- dyna3d code应用及开发手册，非常稀有。(DYNA3D development manual, very rare.)
ST LINK驱动及教程
- 这是关与电机驱动的代码程序解释，设计了stm32的电路连线，以及外设的使用(This is explained by code program driven by motor, designed stm 32 circuit connection, and use of peripherals)
MT6261_GC6153_Driver_V0.2010.110
- 格科微GC6153模组驱动代码，QVGA，SPI接口，240*320(Gc6153 module driver code, QVGA, SPI interface, 240 * 320)
slipBERI-master
- slipBERI是一个基于matlab的滑动分布反演程序，它利用大地测量数据（InSAR/GNSS）求解地震滑动。(slipBERI is a matlab slip inversion code, that uses geodetic data (InSAR/GNSS) to solve for earthquake slip at depth in a Bayesian sense. The primary purpose of this function is to incorporate
4-20mA XTR111正式版
- STM32 硬件PCB 图纸 输出4-20MA电流信号 采集频率信号(STM32 hardware PCB drawing outputs 4-20mA current signal and collects frequency signal)
VIENNARectifierTA_Three_Phase
- 三相整流器psim仿真VIENNARectifierTA_Three_Phase(Three-phase rectifier psim simulation VIENNARectifierTA_Three_Phase)
VC纯MFC实现放大镜
- VC纯MFC实现放大镜,功能都实现了很不错!
fifomap
- c++ 顺序关联容器 很好用,可以代替map容器
两轴高级轨迹规划PVT
- 基于运动控制器的PVT运动控制设置，用于多轴运动控制规划(PVT motion control setup based on motion controller is used for multi axis motion control planning)
syf API插件 3 in 1
- 内涵3个API插件，分别为连接编辑，生成连接图，复制端子。(include three API addin : connection edit, generate connection, copy terminals .)
juli_tuoyin_jifeng
- 用matlba实现拖引干扰的程序，雷达欺骗式干扰。(Using MATLAB to realize the program of towed jamming, radar deception jamming.)
TopOpt-MMA-Python-master
- 采用python语言编写拓扑优化程序，考虑采用MMA(Using Python language to write topology optimization program, considering the use of MMA)