资源列表
hhcit
- Includes the modulation, demodulation, signal to noise ratio calculation, Including AHP, factor analysis, regression analysis, cluster analysis, Noisy pulse correlation detection signal.
vtrb
- % disp('MATLAB encoder output') % disp(u)
basic_uart
- basic code for UART receiver and transmeter
AFMotor测试实例(AFMotor test case)
- Arduino_AFMotor库，用于控制连在Arduino上的电机(Arduino_AFMotor library is used to control motors connected to the Arduino)
TIME_5
- 利用T0实现对外部脉冲的计数，利用按键模拟产生外部脉冲。计数值为1,4,7……时，LED0亮，LED1灭；计数值为2,5,8……时，LED1亮，LED0灭；每满10次计数，蜂鸣器鸣叫。(Using T0 to achieve external pulse count, the use of key to simulate the external pulse. The count value is 1,4,7...... When LED0 is bright and LED1 is out,
STM8S-USB-master
- 用stm8s的io口模拟 usb hid设备，包含pcb图纸，仅供参考，无实际测试(With stm8s IO port analog USB HID device, including PCB drawings, for reference only, without practical testing)
12864贪吃蛇
- 用stc单片机实现 贪吃蛇游戏，stc驱动12864液晶实现(With STC SCM Snake game, STC drive 12864 LCD implementation)
RS232_verilog1
- RS232通信协议verilog程序。经过调试可以使用(RS232 communication protocol Verilog program. After debugging can be used)
实验四_外中断实验
- 通过按键触发外中断，实现蜂鸣器及数码管的控制(Trigger through the button to interrupt, to achieve the buzzer and digital control)
多功能锂电池充电器程序3.0
- 通过单片机stm32f103rbt6来采集充电回路上的电流和电压，然后经过算法处理后输出相应的PWM信号来驱动开关管，从而控制BUCK电路实现对锂电池的闭环充电控制。(Through the MCU stm32f103rbt6 to collect the charging current and voltage loop, and then through the algorithm outputs the PWM signal corresponding to the driving swi
16f73逆变器
- 通过PIC16F73单极性做PWM控制作逆变器(By PIC16F73 unipolar, PWM control is used as inverter)
lcd with pic
- lcd interface with pic controller