资源列表
JLINKV8
- 包含程序源代码及各个模块的头文件和其他信息(Contains the source code of the program and the header files and other information of each module)
NVSP0019_SDK_N76E003_TX_V02
- MCU实现无线充电Tx 端的方案， 源代码(Wireless Charger Tx Demo Code)
GY-85-arduino-master-new
- 这是一个通过用arduino控制GY-85九轴陀螺仪的例程，包括收集gy85传感器发回来的数据，以及将它们打印出来(This is an example to control GY-85 by using arduino)
UPS
- UPS with AVR project
电机速度控制和速度检测
- STM32编码器，单位脉冲读取时间，电机速度控制和速度检测。(Speed control and speed detection of motor)
FHL-NPB06
- 系统采用义隆单片机实现了移动电源功能，代码仅供参考！(the source code for mobile power supply)
SPWM
- 利用PIC16F716产生SPWM控制全桥逆变器DC12V-AC220(Using PIC16F716 to produce SPWM control full bridge inverter DC12V-AC220)
1602显示-NTC公式测量
- C语言开发的ntc测温程序，测温精准，占用内存小。希望能帮助到你。(NTC check tempreture programm by C on keil.I hope it can help you.)
stm8的SPI初始化处理部分
- SPi初始化，验证可正常使用，没有中断，DMA(SPi initialization, validation can be used normally)
stm32SPI SD
- 项目用到的STM32F103芯片SPI接口的SD卡读取与改写存储，带文件操作FAT32操作系统，绝对可以用。(The STM32F103 chip SPI interface of the project uses the SD card reading and rewriting storage, and the file operates the FAT32 operating system, which is absolutely available.)
stm32CtlBoard_oldbroad_1121_1619
- stm32+l6470控制两路步进电机。 监控摄像头球机驱动程序(Stm32+l6470 controls two step motor. Monitor camera ball driver)
2_Keil_XMC1300-电流采样
- 本程序通过对xmc1300中VADC模块的设置，采集电机三相电流值。(This program collects the three-phase current value of the motor through the setting of the VADC module in xmc1300.)