资源列表
Mcbsp gpio
- this code shows the way to setup a dsp kit used as a general purpose input output
STM32POV2604PI2C
- 这个是用stm32实现对ov2640的操作，使用iic作为通信，很有实用价值。-This is achieved by stm32 on ov2640 operation, use iic as communications, very practical value.
8051-LCD-Driver
- 8051单片机实现LCD显示的例子，是Proteus 7 Professional上的仿真例子程序。可以仿真-Examples 8051 LCD Display is the simulation example Proteus 7 Professional on. Can simulate
06_Debounce
- debounce program for PIC micro controller
ALIENTEK-MINISTM32-ADC--
- 不错的源码战舰ad转换 可以直接引用，-Good source warships ad conversion can be directly quoted,
lm35 mega8
- lm35 with lcd2*16 and mega8
flash_led
- 运用51单片机实现流水灯的c语言源程序。-Use light water 51 MCU c language source code.
jiaotongdeng-
- 十字路口交通灯，南北向为主干道，东西向为支道，每个道口安装一组交通灯：红、黄、绿。设计十字路口的交通灯控制器，使交通灯按状态1 状态2 状态3 状态4 的规律变化，循环不止。 状态1：东西向绿灯亮，南北向红灯亮，其他灯全灭，保持30 秒 状态2：东西向黄灯亮，南北向红灯亮，其他灯全灭，保持5 秒 状态3：东西向红灯亮，南北向绿灯亮，其他灯全灭，保持20 秒 状态4：东西向红灯亮，南北向黄灯亮，其他灯全灭，保持5 秒-Crossroads of traffic lights,
4x4jianpan-
- 由P1端口的高4位和低4位构成4乘4的矩阵键盘，本程序只能单键操，同时按多键时无效。-Upper 4 bits and the lower 4 bits of the P1 ports constitute a 4 by 4 matrix keyboard, Dan Jiancao this program only, press more than one key is invalid.
chuanxingkou
- 使用晶体频率为22.1184MHz的AT89C52单片机，串行口应用工作方式1，以9600bps的波特率向外发送数据，数据为十个数字‘0’到‘9’，循环不断地发送。-Use AT89C52 microcontroller 22.1184MHz crystal frequency, and a serial port applications work in order to send out the baud rate of 9600bps data, as ten numbers ' 0
yinjiaoshuchu-
- 51单片机几种常用引脚输出的编程方法，内有具体说明。-51 microcontroller programming several common output pins, there are specific instructions.
4x6_horizontal_MSB_1
- 4x6 Font is included in 16 variants: - Assembler and C header (.asm / .h) - Horizontal and Vertical arranged bits (horizontal / vertical) - Mirrored and non-mirrored (MSB / LSB) - Left or top aligned, right-aligned or bottom (1/2). For font