资源列表
6
- 实验电路如图25，按虚线连接电路：CLK0接1MHz，GATE0，GATE1，接+5V，OUT0接CLK1，OUT1接PA0，PC0接继电器驱动电路的开关输入端Ik。继电器常开触点串联一个220V灯泡，接交流220V。编程使用8253定时，让继电器周而复始的闭合5秒钟（指示灯灯亮），断开5秒钟（指示灯灯灭）-The experimental circuit shown in Figure 25, connected by dotted line circuit: CLK0 connected
595SMG
- 595数码管驱动，用于51单片机，使用3个io口，串行驱动数码管-595 digital tube-driven, for 51 MCU, using 3 io port, serial driver digital tube
jianpan
- 矩阵键盘的识别，4*4矩阵键盘识别，按那个，显示相应的数值-Identification of the keyboard matrix, 4* 4 matrix keyboard identification, according to that, show the corresponding numerical
juzhengjianpanrar
- 本程序是数码管和矩阵键盘的结合程序，按动16个键盘中的任意一个，数码管现实就会变化-This program is the digital control and the combination of the keyboard matrix procedure, press 16 in any of the keyboard, digital tube will change reality
adc1
- this the program for adc for microcontroller 8051-this is the program for adc for microcontroller 8051
shumaguanxianshichengxu
- 数码管可以静态显示，亦可以动态显示。本程序是用keil软件编写的数码管动态显示的c程序。-LED display can be static, but also can be dynamically displayed. The program is written in keil software digital dynamic display c program.
shumaguanxianshianjian
- 51单片机控制LCD显示时间，LCD为1602两行显示黑白屏-51 single-chip LCD display time control, LCD display for the 1602 two-line black and white screen
motor
- 步进电机演示程序 目标器件：AT89S51 晶振:11.0592MHZ 编译环境：Keil 7.50A -Stepper motor demo program the target device: the AT89S51 crystal: the 11.0592MHZ compile environment: the Keil 7.50A
430LED
- MSP430G2553上LED控制程序，普通的I/O口操作-MSP430G2553 on LED control procedures, common I/O port operation
24c02
- 24c02存储芯片的驱动，供单片机学习者参考，本人经常用的-24c02
traffic-light-
- 此程序是用周立功芯片搭建的配合按键设置时钟倒计时。-This program is built with ZLG chip keys to set the clock countdown.
exp08
- 51单片机Keil C程序：数码管动态显示，用8位数码管动态显示多位数字。-the Keil C programs in 51 MCU: dynamicallyt displaying many numbers with a 8 digitals tube.