资源列表
usb-kard-reader
- 利用一块HY-STM32开发板的SD卡及USB接口实现板上的U盘功能。-An HY-STM32 development board SD card and USB interface board U-disk function.
_xinhaofashengqi
- 信号发生器，编写程序下载到FPGA运行，产生所需信号。 -Signal generator, programming downloaded to the FPGA to run, to produce the desired signal.
ISEPrj
- Xilinx Zynq的PS+PL使用，用PS添加IP核，然后从IP核添加GPIO，并与板上LED相连，实现led的逻辑。注意不能使用helloworld模板。-For the Xilinx Zynq PS+ PL, PS Add IP core, and then add GPIO IP core and connected to the on-board LED, led logic
classroom - 副本
- 智能教室监控系统：可以检测温度湿度，空气质量，还可以进行学生考勤(Play pause and so on)
kenandaxia--ucGUI
- 经典案例-柯南大虾ucos人机交互界面，基于stm32单片机-Classic Case- Conan prawns ucos interactive interface
s5
- 清华大学电子系 时序逻辑实验报告 包括：触发器设计，计数器设计，累加器设计，序列检测器设计/有限状态机实现-Tsinghua University, Department of Electronics, sequential logic test report include: trigger design, counter design, accumulator design, the sequence detector design/finite state machine
Sample
- 通过AD9221 采集数据 然后将输出传给FPGA 通过串口MAX232显示采集回来的图形-Through the AD9221 data collection and then will output through a serial port MAX232 shows to FPGA collection back graphics
Vivado 简明教程
- vivado简明教程 vivado入门教程 vivado简易教程(vivado API Tutorial Vivado)
STM32+uCOS-II模板(2.86)
- STM32+uCOS-II工程模板，该模板中，存在一个点灯程序(STM32+uCOS-II project template, there is a lighting program in this template)
wind_bai_system
- 全国大学生电子设计竞赛题目风力摆控制系统，底部采用4个风扇通过风力摆动，顶部用万向节连接，采用STM32主控器，MPU6050测量倾角，TB6612驱动风扇。可实现摆直线，摆任意角度，摆圆周等项目。(National University Students Electronic Design Competition Wind Pendulum Control System, the bottom of the four fans through the wind swing, the top w
STM32F407 OLED_IIC
- OLED_LLC显示程序，简单，高效。可读性强可以显示各种字(OLED_LLC display program, simple, efficient. Good readability can display a variety of words)
licheng
- 英飞凌单片机XC164CM的例程集，包括了AD等常用模块的基本使用方法，适合初学者-Infineon microcontroller XC164CM routines, including the AD modules commonly used basic use, suitable for beginners