资源列表
UART
- 同时使用STM32三个串口的接收与发送，串口1使用printf(),串口2使用u2_printf(),串口3使用u3_printf().接受采用定时器中断超时，5ms未接收到数据认为本次接收结束，置位相应的标志位，主程序检测并处理接收数据。-STM32 simultaneously receive and send three serial, serial port 1 to use printf (), 2 serial ports use u2_printf (), 3 serial por
ADPUARTPDPRAM
- ad7606采集信号数据存入双口ram再通过串口发送出去。- ad7606 collected signal data stored in the dual port ram and then sent through the serial port.
dds
- 包括了DDS的版图（其中包括PCB和原理图），开发源代码，都已经通过调试，效果很好，可以放心使用-Including the territory of the DDS (including PCB and schematic), development source code, has passed debugging, the effect is very good, you can rest assured that the use of
Proteus_Video_Tutorial1
- Tutorial for Proteus 1 Create PIC and LCD Display project
arm7_led_driver
- arm7下的led驱动，还附有文档介绍，对初学arm的人是很好的参考。希望能对大家有用。-ARM7 led the drive, but also with documents, the right arm when a person is a good reference. Hope can be useful for all.
0806v020046source
- 瑞萨的串口程序下载工具FlashStart源代码 开发环境VC6.0 支持M16C/80 BOOTLOADER ,M16C/10 FLASH START的下载-program download tool source code by renesas with VC6.0 Support M16C/80 BOOTLOADER ,M16C/10 FLASH START download
fsmc_fpga
- FPGA和STM32通讯的例子，keil和quartus软件程序-Examples of FPGA and STM32 communications, keil and quartus software program
ID-TVM-CRU
- 这是一个应用FID的程序，主要用了CLRC632，网上的资料真的很少，这个是 测试的-This is an application TFID program mainly used CLRC632, really very little information online, this is a test
MSP430
- MSP430单片机基础与实践 -MSP430 MCU-based practice MSP430 MCU-based practice
caculator-a-snake
- 用ucgui模拟器写的计算器和贪食蛇,ucgui模拟器可在vc6.0和vs2008上运行-a caculator and snake by ucgui siulator
Based-on-STM32-USB
- 基于Cortex-M3的USB，支持热插拔。-Based on the Cortex-M3 USB, support hot swaps.