资源列表
0802LCD
- 0802液晶显示：在LCD 屏幕上显示广告词（51单片机控制）-0802 LCD : LCD screen shows the words (51 MCU control)
ssss.rar
- 采用8位LED动态扫描时钟演示程序，使用12MHZ晶振，P0口输出段码，P2口作列扫描，用共阳LED数码管。,Using 8-bit dynamic scanning LED clock demonstration, the use of 12MHZ crystal, P0 port output above code, P2 scan I made out with a total of LED digital tube Yang.
xunji
- 通过8051单片机控制小车循迹，可做90度转弯，简单明了-Car tracking control through 8051, can do 90-degree turns, straightforward
send
- 用C实现信号发生装置：1、正弦波：频率、幅度可调。 2、三角波：频率、幅度可调。 3、方 波：频率、幅度、占空比可调。 4、按键：波形切换、频率调节、幅度调节、方波占空比调节。 5、显示：信号的频率、幅度，在方波时还要显示占空比。 -Implementation using C Signal: 1, sine wave: frequency, amplitude adjustable. 2, triangle-wave: frequency, amplitude adjust
lcd
- 12864专用驱动C程序 有需要的朋友可与我联系-this is my C
fft
- 关于vhdl-FPGA实现fft算法的模块-MATLAB VHDL ADN EDA
light
- 流水灯，51单片机C程序，流水灯的控制，比较简单的一个程序-light
MMA7361-angle-test
- 采用三轴加速度传感器MMA7361测试运动物体的转动角度程序-Using triaxial accelerometer MMA7361 test procedures moving object rotation angle
18b20
- 单总线协议 用于温度传感器18b20 已测试成功-Single bus protocol is used for temperature sensor has been tested successfully 18b20
pcm_unlock_rdreg_prog
- 在NEXYS3开发板上，对于PCM的写操作时序-the time of programming PCM on NEXYS3
eeprom241025
- This the source code for 24XX1025 EEPROM. the main funtion of the code is to provide easy access to the above mention eeprom. There are only three basic funtions. One of the funtion is for initialising the eeprom and the second one is to read data by
Asynchronous
- 异步加法计数器，采用D触发器实现的二进制计数器-Asynchronous adding counter using D flip-flop to achieve binary counter