资源列表
ee24_h
- 实验目的：熟悉MSSP通信协议。当按键RB0按下时，把6个连续的数据写入到6个连续的单元内，写完成后数码管显示单个0，做为完成标志位，当按键RB1按下后读取EEPROM连续六个单元读取结果送6位数码管显示-Experimental Objective: MSSP familiar with communication protocols. When the button is pressed RB0 to 6 consecutive write data to the unit for six
c8051f040_moto_step
- C8051F040 控制两相四线步进电机调试程序-C8051F040 control of two-phase four-wire stepper motor debugger
IIC
- IIC通讯协议，包括起始信号、停止信号、应答信号-IIC communication protocols, including the starting signal, stop signal, response signal
stc125410ad
- stc12c5410ad电压采集ad转换，串口调试，自己写的并经过调试下载成功的了。请放心使用学习-stc12c5410ad voltage collection ad RXD TXD
hongwaishoufa
- 本程序通过C语言来实现红外模块功能，进行红外模块的收发功能-The C language to implement the program through the infrared module functions, the infrared transceiver module function
444
- 控制电梯的c语言程序，电梯共5层，程序实现电梯的停止及运行-C language program to control the elevator, the elevator a total of five layers, program the elevator to stop and run
KEY-CONTROL-PWM-LED
- c语言开发单片机 控制跑马灯的亮度的变化 按键控制亮度增减-C develop SCM Control the brightness of the scrolling the change of control buttons increase or decrease brightness
disp
- 用数码管前两位显示一个十进制数，变化范围为00~59，开始时显示00，每按下S2键一次，数值加1；每按下S3键一次，数值减1；每按下S4键一次，数值归零；按下S5键一次，利用定时器功能使数值开始自动每秒加1，再次按下S5键，数值停止加1，保持显示原数。-Digital tube first two shows a decimal number, range 00 to 59, the beginning of display 00, press S2 button once, increment
yejingzongxian
- 液晶动态显示程序和单片机利用总线进行传输数据的代码-LCD display dynamic program and single-chip bus transfer data code
PIC16F1936qudong5110LCD
- PIC16F1936驱动5110LCD液晶程序 ，C程序，MPLAB开发环境-PIC16F1936 drive 5110 LCD procedures, C program, MPLAB development environment
ad_0834-ds18b20
- 压缩包里有我们非常常用的子程序，包括DB18B20，ad_0834，在单片机开发中可以直接调用，也有比较好的注释，对于新手是不错的选择-Compression bag has us very common subroutines, including DB18B20, ad_0834, in microcontroller development can be called directly, but also a better note, is a good choice for the no
led
- 用单片机来实现led灯的动态显示，节约材料的条件下，来达到各种要求-MCU led lights to achieve dynamic display, saving material under conditions, to achieve the various requirements