资源列表
djs
- 按SW19独立按键，倒计时开始 倒计时期间 继电器吸合 按SW20键继电器断开 计时暂停 按板上单片机复位按键 计数值恢复为999 此计数初值 可在程序中修改。-Press SW19 independent button during the countdown to begin the countdown relay pull-off time by SW20 key relay suspended by the board microcontroller counts reset butto
I2C
- 采用51单片机模拟I2C串行总线通信的C语言头文件，在Protues下仿真通过-51 SCM simulation with I2C serial bus communication of the C language header files, in the next simulation by Protues
xx
- C语言写的8051的时钟代码 -C program for 8051 a clock code
Frequencymeter
- 基于单片机的频率计设计，对于刚开始学习单片机设计的同学会很有帮助哦-Frequency meter based on single chip
huang1
- RS232串口通信的51单片机通信病处理并行输出的汇编程序-51 RS232 serial communication processing microcomputer communication disease assembler parallel output
ch452x
- c8051f020 矩阵键盘程序 串行控制-c8051f020 key
MF
- 飞行器多轴的KK的电控keil源代码HEX-HEX of keil KK code on molor model fly
STC89C51zhiliudianji
- STC89C51单片机控制直流电机驱动程序-The SCM STC89C51 control of DC motor driver
key
- 利用51单片机做的一个按键扫描的程序，介绍了按键扫描的步骤和对消抖的一些处理。-51 MCU to do a key scan program, the steps of the key scan and debounce processing.
RFM01
- RMF01无线射频代码，具有参考，代码经测验，能过使用给函数为罚函数-Radio frequency code RMF01, a reference, the code has been tested, can use to function as a penalty function
ADC0832
- 一个ADC0832模数转换的代码。使用c语言进行编写。-An ADC0832 analog-to-digital conversion of the code. Use c language to be written.
xs128PLL-and-pwmInit
- xs128利用PLL锁相环技术超频设置及pwm初始化设置-xs128 PLL and PWM init