资源列表
ad9850
- ad9850串行扫频程序，扫频范围有1hz到200khz，可以自己增加。-Ad9850 serial swept-frequency program, sweep frequency range 1hz have to 200khz, can increase.
PID
- PID控制器的源代码，并附有PID控制器用法的解释。-PID controller source code, together with the PID controller usage explanation.
can5
- can总线收发器MCP2515源程序5，用于can总线收发芯片的调试 -Bus Transceiver MCP2515 can source 5, for the can bus transceiver chip debugging
timer_con
- stc单片机的关于计数器的驱动程序，需要的稍微改下就好了-stc microcontroller driver on the counter, needed a little change like the following
ADS8320
- C8051单片机实现16位数模转换器ADS8320驱动程序，Keil环境下编译通过。-C8051 MCU drivers for 16-bit digital to analog converter ADS8320, Keil environment compile.
ST7549
- ST 7534液晶模组测试程序，欢迎下载测试-ST 7534 LCD module test procedures, please download the test. . .
head1621b
- 单片机C语言编写，HT1621B的头文件。-c language mcu ht1621b
HT1621
- ht1621驱动lcd,自主开发的，请放心下载-ht1621 driver lcd, independently developed, please be assured Download
TheExpandTimer
- 51单片机利用基本定时器扩充的8个软件定时器，运行效果较为良好。-Expanding access to basic timer 51 MCU 8 software timer, operating results are more good.
can
- CAN通信驱动程序，在汽车电子设备上实际应用-can.c
MB11504C
- MB1504锁相环控制程序，已经调试通过，是本人参加比赛时写的程序，方便移植和应用-MB1504 PLL control procedures, has been debugged, is the race when I write the program to facilitate the transfer and application of
dian
- 低频频率计，选用24MHz的晶体，主频可达2MHz。用T1产生100us的时标，T0作信号脉冲计数器。假设晶体频率没有误差，而且稳定不变（实际上可达万分之一）；被测信号是周期性矩形波（正负脉冲宽度都不能小于0.5us），频率小于1MHz，大于1Hz。要求测量时标1S，测量精度为0.1 -Low frequency, use 24MHz crystal, frequency up to 2MHz. Generate 100us with a time scale T1, T0 for the si