资源列表
keyboard
- 本代码实现4×4键盘操作 对键盘进行扫描取得键入值
12864p
- 12864的並口驅動程序，可以輿12232通用，可直接使用。
Key
- 利用单片机扩展8155芯片 4*4键盘扫描
LCD
- LCD显示控制 2*16LCD显示器 C51编程
CPU-24C02
- 这是一个单片机与24C02的读写的程序，可根椐需求相应的更改-This is a reading and writing 24C02 MCU and procedures, may show demand for the root corresponding change
clock
- 单片机时钟 -Single-chip Single-chip clock clock
EEPROM(AT24C02)
- 用C写的基于单片机控制AT24C02 I2C串行总线EEPROM的读写程序。-Written by C MCU AT24C02 I2C serial bus EEPROM reading and writing process.
C_u002
- C51单片机的串口通信程序（C语言环境下）。-C program on C51
74HC164
- 74HC164硬件驱动程序，Keil软件开发，C语言-74HC164 hardware driver program，Keil software IDE，C lagvage
Spi--many-communications
- SPI通信（多从设备）——ARM的Proteus实验-Spi （ many communications from equipment ）
UART-RX-INTRUPPT
- RAM2410串口通讯中，通过用串口中断来接收其他串口发送过来的数据-RAM2410 serial communication, by using the serial port interrupt to receive other data sent over the serial port
nuc140-i2c-s3c2440
- linux下S3C2440通过I2C跟nuc单片机互通，关键是单片机i2c地址的选择很坑爹，试了很久终于成功打通了-Under linux S3C2440 microcontroller via I2C with nuc interoperability, the key is the choice of microcontroller i2c address very pit father, tried for a long time and finally succeeded to get