资源列表
guihuaxiang
- 本程序是一个汇编程序,是8月桂花香的程序。
test_info
- 是基于51的串口测试程序，本程序可以实现串口的接受和发送。
Untitled.rar
- 《基于平均功率受限和有约束条件注水原理的MIMO联合自适应调制和功率分配算法的主要源代码》," Based on the average power is limited and bound by the conditions of injection of the principle of joint MIMO adaptive modulation and power allocation algorithm is the main source code"
11
- AT89C51单片机 音乐门铃的程序 共六首音乐-AT89C51 single-chip procedure doorbell music a total of six music
newyejingceshi
- 显示点阵液晶，经过测试，完全正确，相信对利用AVR进行液晶显示的人很有用。-show LCD with AVR MCU
ds18b20
- 经典的温度传感器DS18B20在51 中的应用-Temperature sensor DS18B20 classic application of the 51
pwm-8
- c8051,PCA工作在8位脉宽调制器工作方式，在PWM引脚输出一个占空比为0<-->0xfe的PWM 信号且重复输出，可用示波器观察占空比变化。-c8051, PCA in 8-bit pulse width modulator works, the PWM pin outputs a duty cycle 0 < -> 0xfe the PWM signal and repeat the output duty cycle changes can be an osc
PIC_UART
- UART发送数据 中断接受数据 UART发送数据 中断接受数据-UART transmit data UART interrupt receive
DFA
- deterministic finite automata
ee9346_s
- 基于PIC16F877A的单片机的SPI通信的9346 基于PIC16F877A的单片机的SPI通信的9346-PIC16F877A microcontroller based on the SPI communication 9346 PIC16F877A microcontroller based on the SPI communication 9346
LCD-display-point-formations
- 本文介绍了LCD显示在visual C++环境中的编程，可以运用到proteus的设计中。且为点阵形式。-This article describes the LCD display in the visual C++ programming environment, can be applied to the design of proteus. And the lattice form.
msp430g2xx3_uscia0_uart_01_9600
- MSP430单片机的UART实验，此处波特率设为9600.-The MSP430 microcontroller UART experimental, here baud rate is set to 9600.