资源列表
MotorSpeed
- 电机调速程序，用单片机编写程序，连接步进电机，可以对步进电机调速。-Motor Speed Control program, with the microcontroller programming, connect stepper motors, stepper motors can be speed.
yinyue
- 单片机音乐播放程序C语言 本程序的单片机晶振采用11.0592M -The music program of the microcontroller crystal oscillator used 11.0592M
1602xs
- 一个关于液晶显示器LCD1602在C语言编程上的应用。-LCD monitor LCD1602 one on C language programming in the application.
C8051F040-CAN
- C8051F040对CAN总线配置子程序-C8051F040 on the CAN bus configuration
lsd
- 此代码运用于单片机C程序代码，可以实现流水灯功能-circle led
1111
- 基于火牛开发板的信号发生器的设计，这是其中的一部分程序，欢迎-signal generator
MAX7219C
- MAX7219 的C51程序 采用51单片机 调试通过 模拟引脚驱动 -The MAX7219 the C51 program 51 single-chip debug pin is driven through an analog
LED
- 小灯点亮测试代码，比较简短，不要见怪，-Small lamp lit test code, relatively brief,
JTD
- 本程序通过红、黄、绿三种发光二极管模拟交通信号灯，时间间隔可随意调整-This program through red, yellow, and green light-emitting diode simulation of traffic lights, the time interval can be adjusted
Stepper-motor
- 用单片机驱动ULN2003去控制步进电机，数码管旋转的角度会在数码管上进行显示。-MCU ULN2003 to drive stepper motor control, digital control rotation angle will be displayed on the digital pipe.
AD-and-serial-communication
- 通过AD转化和串口通信，将单片机的电压实时的传送到电脑串口助手上-Through the conversion of AD and serial communication, the voltage of the single chip computer to the computer serial assistant
adc
- STM8S的ADC采样配置，拿来就可以用，已经调试过。采样值采用求平均的方法，当然也可以采用冒泡排序法，看自己的需求。-STM8S ADC sample configuration used can be used, it has been tuned. Samples using the averaging method, of course, can also be used bubble sort method, see their needs.