资源列表
DSP28_Gpio
- 适合DSP初学者的小程序-DSP28_Gpio.c DSP28_Gpio.c DSP28_Gpio.c
Fir
- 一个关于数字信号处理中FIR算法的c语言源程序，可以通过在TI公司的CCS软件中硬件仿真或软件仿真产生波形-On digital signal processing algorithm in the FIR of the c language source code is available through the TI' s CCS software or hardware simulation software simulation waveforms generated
my_gold
- 基于FPGA的gold码发生器，用VHDL语言编写的源程序。-The gold code generator based on FPGA, VHDL language with the source.
fft
- DSP code for FFT algorithm
dianya
- 利用单片机和A/D转换器设计一个测量系统，可以实现0~5V的模拟电压，并在数码管上显示出来。-Single-chip computer and A/D converter design a measurement system that can achieve 0 ~ 5V analog voltage and digital display.
danpianji
- 单片机电子琴程序 实现输出7个不同的音符 do re mi fa so la xi-microcontroller keyboard program output of seven different notes
dianyaliangdu
- msp430G2231通过AD对电压采集，在P1.6的灯的亮度上实时反映电压大小，在低频是可看到呼吸灯效果-msp430G2231 collected by AD on voltage, voltage magnitude in real time to reflect on the brightness of the P1.6 lights can be seen in the low-frequency breathing light effect
1602
- 实现1602第一行从左侧移入“Hello everyone!”同时第二行从右侧移入“Welcome to here!”，移入速度自定，然后停留在屏幕上。-1602 The first line moved from the left side of the " Hello everyone!" While the second line from the right side moved to the " Welcome to here!" , Moved to
EEPROM
- c51单片机程序 keil环境下 EEPROM读写程序-the keil c51 microcontroller program environment EEPROM read and write procedures
protect_a
- 本程序是关于电力继电保护的A相电流的速断保护程序-This program is a quick break saver power relay A phase current
46xx_ad_sample
- 该例子使用ht46r47对pb0的电压进行侦测，如果电压超过0.3v Port A 输出FFH,低于0.3v输出00H-This example uses ht46r47 right pb0 voltage detect, if the voltage exceeds 0.3v Port A output FFH, 00H below 0.3v output
config_fuse_dsPIC33FJ128MC510A
- 33FJ128MC510A的熔丝位配置代码，经过加密。下载端口为PCG2-33FJ128MC510A fuse configuration