资源列表
dataflash_boot
- at91rm9200从dataflash启动的程序 -at91rm9200 dataflash activated from the procedure
ucosAT91RM9200
- UcOS2.76在ATMEL AT91RM9200 ARM9上的移植代码，在IAR中调试通过。-UcOS2.76 ATMEL AT91RM9200 ARM9 in the transplant code IAR in the debug through.
F350_ADC_Buffered_2
- c8051f350ADC采样程序,已经通过编译运行的程序．请放心使用-c8051f350ADC sampling procedures have been adopted compiler operation procedures. Please be assured use
LPCDEMO
- ＬＰＣARM的工程模版，用于ads12；另外包括一些列的214X例程；减少零开发-LPCARM project templates for ads12; Also included are some of the 214X routines; Zero reduce development
LPCSPI
- LPC214x SPI例程；飞利浦的ＡＲＭ，带有ｕｓｂ２．０圈速接口，高超性价比-LPC214x SPI routines; Philips ARM, with speed usb2.0 ring interface, superb performance-cost ratio
TAS1020BFirmwareDevelopmentKit
- Ti tas1020B芯片的开发固件，usb1.1协议的兼容包；专用音频开发-Ti tas1020B chip firmware development, usb1.1 agreements compatible packages; Exclusive Audio Development
Sam_2V1.2_8X
- GPS programme for changchun at 8X-GPS program for changchun at 8X
dongli_24h
- 这段源码包括7279驱动，密钥解密和1－99小时自动切换功能，以用余产品上，结对值得参考。-this source, including 7,279 drivers, and the decryption key 1-99 hour automatic switching function, I used to products, forming a good reference.
2006410211915
- 24C512串行程序的使用说明,看看吧,也许对你会有用的-24C512 Serial procedures for use, let's see it, perhaps you will have to use the
USB2I2C_DEMO
- USB2I2C usb总线转i2c总线的专用芯片，无需固件编程。I2C接口支持4种不同时钟传输速度：100KHz/400KHz/750KHz。-USB2I2C usb bus to the bus i2c ASIC, firmware without programming. I2C interface supports four different clock speeds : 100KHz/400KHz/750KHz.
LPC2000_CAN_Driver_Demo
- 飞利浦LPC2000系列CAN控制器驱动程序-CAN Controller Driver
Atmeg8_program_for_Inkjet_printer
- Atmega8，我编制的控制机器的波形输出程序，对初学着有参考价值-Atmega8, I compiled the control machinery waveform output procedures, a novice with a reference value