资源列表
UART.H
- MCU 单片机级的串口驱动程序，适合初学者！-MCU-level serial driver, suitable for beginners!
Readkey
- 通过单片机的模拟通道来处理按键的例程，读模拟通道的寄存器，用多次采样，求平均值的方法处理-Through the single-chip analog channels to deal with the routine buttons, reading the register analog channel, and multi-sampling, and the average approach
dianyabiao
- AT89S52单片机控制的电压表，通过AD转换将电压数值显示出来-89 52 AT S Microcontroller form the voltage control through AD change the voltage value displayed
XiaoDou
- 单片机的程序，初学者的一个有用的单片机程序，是消除抖动的程序-SCM procedures, a useful beginner' s single-chip process, the procedure is to remove jitter
1602_code
- 液晶1602显示程序，环境AT89S52，初学单片机必须的技术-1602 LCD display program, the environment AT89S52, beginner microcontroller technology must be
juzhenjianpan
- 4*4矩阵键盘扫描。扫描后的值扫到4位数码管显示。-4* 4 matrix keyboard scanning. The value after scanning sweep to four digital tube display.
pwmRC_SERVO
- 关于用PWM控制舵机的好资料，直接复制即可 SYSCLK=12MHz PCACLK=1MHz与系统时钟48MHz,PCA时钟4MHz,PWM周期70Hz,需要0x37CE*4=0xDF36个PWM周期,计数递增到0xFFFF后溢出-PWM control on the steering gear with good information, you can directly copy the SYSCLK = 12MHz PCACLK = 1MHz and the system clock
LED_6
- 左右跑马灯，用51单片机实现led灯分别从左和右开始顺序闪烁-the led light on from the left and the right in order
qq
- 8155 键盘及显示接口 使TDN-MI叫教学实验系统-8155 keyboard and display interface that TDN-MI experimental system called the Teaching
1
- 这是一个使用51单片机加上L298驱动直流电机的程序源代码。-This is a single chip using 51 L298-driven DC motor with source code.
zhiliudianji
- 直流电机程序 开发环境 单片机编程软件。-DC motor program development environment microcontroller programming software.
adda
- 89c51的单片机，D/A和A/D联合转换，并用数码管显示转换值-89c51 microcontroller, D/A and A/D co-conversion, and conversion values with digital display