资源列表
send
- 单片机中，基于方式1的单工通信，此程序详细写出了数据发送的代码-Microcomputer-based approach a single-industry communication, this procedure in detail to write code to send the data
SHIZHONGBUYONGZONGDUAN
- 基于51系统的时钟程序，采用外中断调整时间，便于初学者学习使用。-51 system clock based procedure to adjust the time by external interrupt, easy for beginners to learn to use.
lessson423
- 数码管秒表程序，使用定时器0方式1控制，按下按键有停止开始等功能-Digital stopwatch program
Ccs
- 一个单片机点滴测速C程序显示在三位数码管上-A bit microcontroller C programs appear in the three speed digital pipe
sound
- 实现ISD4004语音控制 与51单片机完美兼容-ISD4004 voice control to achieve perfect compatibility with the 51 SCM
512K-flash
- CMOS FLASH MEMORY AT29C040 读写程序，用于单片机ROM扩展-The AT29C040A is a 5-volt-only in-system Flash Programmable and Erasable Read Only Memory (PEROM). Its 4 megabits of memory is organized as 524,288 words by 8 bits.
key-board
- 独立键盘，用于C51的程序，已经尝试过是可以正常的运行的。-Independent of the keyboard, the procedures for the C51, has been tried is the normal operation.
liushuideng
- 单片机的IO口控制八个发光二极管依次点亮，并且按照一定的延迟时间，成流水灯-Microcontroller IO port control eight LEDs were lit, and in accordance with a certain delay, into the water lights
calculator
- 4*4按键protues仿真，另外这套代码还可以继续开发成简单的计算器-4* 4 the key protues simulation, another set of code can also continue to develop into a simple calculator
I-LOVE-U
- 数码管显示I LOVE Y，此程序为51单片机程序，如需使用请自我更改-The digital display I LOVE Y-this program for 51 single-chip program, For self-use, please change
jiaotong
- 单片机入门交通灯必学的程序，带有c语言的源程序。-SCM entry traffic lights will learn the procedures, with c language source code.
chaxunjieshou
- 串行口工作在方式1时，数据为8位，从RXD端输入，从TXD端输出，其波特率固定。在CPU将数据写入发送SBUF寄存器后立即启动发送，待8位数据输完后，硬件自动将TI置为1，TI必须用软件清零。8位数据接收完时，接收SBUF寄存器满，则硬件自动将RI置为1，RI必须用软件清零。-8-bit data transmission is complete, the hardware will automatically TI is set to 1, TI must be cleared by soft