资源列表
单片机电子温度计C源代码
- 本代码是基于STC89C52的简易单片机温度计的源代码。其中八段管的管脚顺序按照实际情况作调整，本代码仅供参考
code
- 本代码是简单单片机实现电子温度计的C源代码，单片机采用国产STC89C52芯片。8段管的管位要根据实际情况来做调整，本例仅供参考。-This code is a simple electronic thermometer MCU C source code, using domestic STC89C52 microcontroller chip. 8-bit segment tube tube to make adjustments according to the actual situat
dianyabiao
- 四路电压表的设计，利用C语言，完成基于单片机的电压表的设计-Design Quad voltmeter, using C language, the completion of microcontroller-based design voltmeter
trans_f
- By comparing elapsed times one can say that Hooke and Jeeves methods converge faster than other methods and the slowest one seems to be Nelder and Mead Simplex Method. In this part of the assignment we are going to reach the solution by using Nelde
Shuzidianrong
- 基于c51的单片机数字电容测试仪设计，有兴趣的可以参考一下-C51 microcontroller based digital capacitance tester design, are interested can refer to
com_claw
- 51单片机应用，控制步进电机丝杆滑块上升，控制舵机爪子开合，通过串口获得命令，波特率9600，偶校验，可用串口助手使用也可作为从机。-8051MCU application,MCU control moto up and down.MCU control claw open and close. bote rate is 9600,enen chek. can be used with com helper or as a sub_MCU.
police_wagon
- 利用51单片机和蜂鸣器发出警笛声，注释详细！-The use of 51 single-chip buzzer sounded and the whistle sound, detailed notes!
ADC10
- msp430F2274的adc10功能转换程序，内含dtc的设置，通过iar调试通过。-adc10 function of msp430F2274 the conversion process, including setting dtc through debugging through iar.
xt3
- 编写串口通信程序，要求PC机先发送02H，单片机发送“HELLO”，如果PC机发送55H，单片机发送“THIS IS A WELL BEGIN!”-Procedures for the preparation of serial communication, PC-request sent to 02H, single-chip microcomputer to send "HELLO", if the PC sent 55H, single-chip microcomputer Send "T
TEST
- 通过矩阵键盘输入，液晶1602或是12232显示某特定值-tongguojuzhenjianpanshuru，yejing1602 or 12232 display
DA
- 10位DATLC5615通过设定可以设定想要输出的电压-10 DATLC5615 by setting the desired output voltage can be set
PIC16F887--PWM-with-50khz
- 单片机16f877输出方波 50HZ 可以根据自己的使用调节脉宽和频率-Microcontroller 16f877 50HZ output square wave can be adjusted according to their width and frequency of use