资源列表
chuang
- 用51单片机对7113初始化和控制,用单片机初始化7113的主要任务是程序的编写，然后根据7113的寄存器操作格式写出读写寄存器的程序，最后根据以上的子程序写出初始化7113的程序段。-7113 Microcontroller with 51 initialization and control, with the single chip initialization 7113 of the main task is to write the program, then operating un
tuowei
- 可以拖尾的8位流水灯,非常好看,已经调试通过,89s82-Water can be 8-bit tail lights, very nice, has been through debugging, 89s82
tc1902
- 红外tc1902的控制程序，实现按键按下，led灯亮灭变化-Infrared tc1902 control procedures to achieve key press, led lights off changes
SPI_finalVersion
- 此程序是针对arduino的SPI 三轴磁传感器编程。可以直接使用。-This program is for arduino programming the SPI-axis magnetic sensor. Can be used directly.
i2c
- i2c protcol,plc2132,ms-51,etc.
13MR
- STC11F02E单片机输入点启动延时输出，控制设备起停。-Microcontroller input start-up delay output control equipment starts and stops.
cs5460
- CS5460驱动程序，读取电压，电流，已经使用，无问题-cs5460—driver code，has been used to factory,
x9c103
- x9c103数字电位器的驱动代码,已调试通过可正常使用-the x9c103 s drive code can be use.
serial3
- 单片机无线模块串口协议1 ，用于毕业设计或者课程设计 No2-wireless No2
SW420_detect
- 震动传感器SW-420感应检测源程序，传感输出低有效。-SW-420 induced vibration sensors to detect the source, the sensor output low.
led
- 单片机学习，数码管静态显示实验C语言编程-MCU learning, digital static display experiment C language programming
Temp_Control
- 使用DS18B20感測環境溫度,取得溫度值後,若達設定警戒溫度,將點亮LED警告燈-After using DS18B20 ambient temperature sensing, to obtain temperature values, set up alert if the temperature warning light will light LED