资源列表
s3c44b0_18B20
- 采用s3c44b0单片机实现18b20温度读写。已通过测试。-Single chip using s3c44b0 18b20 temperature reading and writing. Has been tested.
jishiqi
- 这是光电对管用数码管计时程序。物体掠过管子之间开始计时，在此过去停止计时，程序简单易懂-This is a digital optical timing of effective procedures. Object passing between the tubes start running, stop the clock in the past, the program easy to understand
PWM_wave
- 基于MCS-96单片机的汇编程序，利用PWM输出锯齿波、三角波、正弦波等波形的代码-Based on MCS-96 microcontroller assembler, using PWM output sawtooth, triangle wave, sine wave code such as
28
- 简单的单片机串口通讯程序，开发环境为vc++6.0-Simple serial communication program, the development environment for vc++6.0
1621
- 1621显示程序，能显示很多东西，包括日期，时间，重量等-1621 display program that can display a lot of things, including the date, time, weight, etc.
ICL7135
- 讲解ICL7135AD转换程序，经实验，可行-Explain ICL7135AD conversion process, the experiment, possible
_74HC595_Running_LED_0_255
- IC 74HC595 to Display 8*LED
change_wiper_X9C103
- Four AVR ASM routines for controling the wiper of a digital potentiometer type X9C103.
2_4
- 郭天祥 单片机教程之 用8个发光管演示出8位二进制数累加过程-Guo Tianxiang SCM Guide of 8 led a demonstration of 8 bit binary cumulative process
ff1584189003
- 直流电机调速利用c语言进行调pwm，然后对反馈速度进行分析，从而调整小车速度。包含Proteus仿真程序。-DC motor speed control using c language tune pwm and feedback speed analysis, so as to adjust the car speed. Contains the Proteus simulation》
4
- 单片机开发，用数码管动态显示0到59的自加-MCU development, digital dynamic display self plus 0-59
OTP-WHRITE-CTRL-REV-B-20121020
- LCD 工厂 OTP烧录时电压发生，转换控制程序，电压按照烧录过程启动，停止，升压，降压等-LCD factory OTP Programmer voltage occurs, change control procedures, voltage to start the burning process, stop, step-up, step-down