资源列表
RF1100
- <wendu-fasong>采集温度信息后发送 2． <wendu-jieshou>LCD与接收端底板对接，并且串口线和PC相连，当通信正常情况下， LCD会显示时时温度，当发送端温度变化时，接收端显示温度也变化，当超过预设范围蜂鸣器报警 同时打开PC温度采集界面可以看到界面温度效果，其中波特率选择9600，和串口号 -<wendu-fasong> After collecting temperature information trans
stm32f4_xx移植GRBL_CNC
- stm32f4_xx移植GRBL，使用的是STM32F407，基本上完整的移植了GRBL源代码(Stm32f4_xx transplant GRBL, using STM32F407, basically completely transplant the GRBL source code.)
eeprom_nrf24l01
- 基于stm8的nrf24l01无线串口发射程序，可发送，也可以接收。-Based stm8 of nrf24l01 wireless serial launch program, you can send, can receive.
STM32遥控器
- 该程序实现 adc对双轴传感器的X轴Y轴电压的采集，并用不同的标志位代表双轴传感器不同位置时的电压，利用SPI协议将采集到的数据传递给NRF24L01模块，利用NRF24L01模块将数据发送给下位机，实现与下位机之间的通信。(The program realizes the acquisition of the Y axis voltage of the X axis of the dual axis sensor by ADC, and uses the different symbol bi
匿名四轴代码
- 匿名上位机 四轴代码 及 上位机 ,适合 做四轴 飞控的同学。(Anonymous upper computer and code)
stm32-code
- 讲述STM32103的开发，附件包含各个外设的例程源代码-About STM32103 development, attachment contains the source code for each peripheral routines
Arduino_Stm
- This is embedded software.
STM8S_sensorless_BLDC
- 基于STM8S的无传感器BLDC控制程序，包含上位机控制程序-Based on STM8S sensorless BLDC control motors, including PC control program
22.NAND_FLASH访问(神舟王STM32F407-库函数版)
- 实现nand flash 读写操作 包括读写 插除 读写备用区！(NAND FLASH read and write operations, including reading and writing, plug and drop, read and write standby area!)
旋转LED制作
- 旋转LED制作，有详细资料，自行查看，内含原理图，程序，制作清单，教程等等所以一应俱全的信息，完全可以参考仿制(this is a good project)
stm32-I2C-driver
- 这个是我们四轴飞行器课设时候留下的各种驱动程序和资料，stm32模拟I2C驱动L3G4200,ADXL345,HMC5883,BMP085成功,含大量中文资料-This is our four axis flight vehicle class set time to leave a variety of drivers and data, STM32 simulation I2C driver L3G4200, ADXL345, HMC5883, BMP085 success, with a
auto
- automobile garage management system