资源列表
gpio
- 嵌入式开发中的接口程序，通用IO口，GPIO程序-Embedded development interface program, common IO port, GPIO program
lcd_89c52
- displaying 40x4 LCD using 89c52
OTM8009A_HSD463
- LCD 初始化程序例程：驱动IC OTM8009A ，配玻璃HSD463-LCD initial example:Driver IC(OTM8009A),the LCD (HSD463)
source_tx
- FPGA控制uart 串口发送，使用Verilog语言在quartus II环境下开发-uart tx FPGA verilog
LCD
- program for lcd display
main
- 智能车程序，可以实现循迹功能并且速度较快。-Intelligent Vehicle program, you can achieve the tracking functionality and faster.
DS18B20
- 用mega16来驱动 温度传感器 此传感器为单总线传输，因此对延时函数以及时序要求很高 在写代码时 特别要注意 较为精确的延时函数已经上传上了 耐心找一下就行了-Mega16 temperature sensor with the sensor to drive a single bus transfer, so the timing of the delay function and demanding to write code with particular attention to th
PCF8563-01.rar
- 单片机 c语言编写 注释详细 时钟日历芯片PCF8563的应用,Singlechip c language notes detailed calendar clock chip PCF8563 Application
DS1302
- DS1302驱动程序，只要改下GPIO就可以用了-DS1302 driver, as long as the change under GPIO can be used
rangewithverilog
- 采用冒泡排序的方式在verilog中实现，从而可以实现信号的有序输出，为控制设备提供有序信号。
AD5933I2C_Example
- ADI公司芯片AD5933官方测试代码，AD5933可以测试生物、超声等器件全阻抗。-ADI company chip AD5933 official testing code, AD5933 can test the biological, ultrasonic devices such as whole impedance.
ADC-main
- This example describes how to use the ADC and DMA to transfer continuously converted data from ADC to a data buffer. The ADC is configured to converts continuously ADC channel14. Each time an end of conversion occurs the DMA transfers, in circ