资源列表
icfunc
- 写IC卡的参考代码,应用于读写IC卡的数据,电表,水表开发场合适用-IC cards to write a reference code, used to read and write data on IC cards, electricity meters, water meters to develop the application of occasions
EZ-USB-side
- 键盘通过ZigBee将数据无线发送给计算机-Keyboard via a ZigBee wireless data sent to the computer
ov7725
- OV7725 是30万象素摄像驱动 经修改后直接可以应用于相关项目-OV7725 300,000 pixel camera driver can be applied directly after the revised project
hafinal
- Home automation sorce code
0xfd---00
- keilc51 0xfd 补丁验证程序 SCAN.C(338): warning C280: UpLoadReady : unreferenced label-keilc51 0xfd patch certification procedures SCAN.C (338) : warning C280 type : UpLoadReady : unreferenced label
gpio-test
- 1、将makefile中的 CROSS =/usr/local/arm/2.95.3/bin/arm-linux- CFLAGS+=-I/usr/local/src/2.4.18-rmk7/include CFLAGS+=-I/usr/local/src/2.4.18-rmk7/include/linux CFLAGS+=-I/usr/local/arm/2.95.3/arm-linux/include 路径改为你宿主机上的。 2、#make，来编译驱动模块。 3、
gpio-test
- gpiotest 嵌入式系统下按键驱动源代码-gpiotest embedded system key driver source code
i2c_slave_ref.tar
- stm32f103 descr iption sample program about i2c slave driver
pcd
- Advanced library for arduino PCD8544 display
Leds
- LED PROGAM IN BASCOM
Boot-from-the-start(mega64)
- 工作芯片为mega64，GPIOD(6)上接一个继电器，程序上电后将PORTD(6)置1，延时1.5S后关闭继电器。将继电器接到主机的启动引脚上，即可实现开机自启动。PS，适合那些老主板，没有开机自启功能的主板。-Work chip mega64, then a relay GPIOD (6) on the program after power PORTD (6) is set to 1, after a delay 1.5S closed relay. The relay started o