资源列表
embedded_Matlab_function1
- 描述一个潜入函数，说明了一个马尔科夫跳变系统在已知转移概率下的仿真 -Describe a dive into the function，illustrate a markov jump to change system known probability in transfer simulation
suijixulie
- 描述全部已知马尔科夫跳变系统的转移概率的一个生成模态-Describe all known markov jump to change the system transition probability of a generation mode
nnrbf_pid
- 在MATLAB中使用，S函数现实RBF-PID控制程序。 -S function of the reality on RBF-PID control
oap2
- 最优阵列处理中的波束形成算法（包括均匀加权线阵、阵列调向、线性孔径、阵列性能度量的程序）-optimun array processing
ch4figs
- 最优波束形成算法（标准矩形阵列的波束方向图的幅度、切面极坐标、切面图、幅度等高线图等）-Optimal beamforming algorithm (standard rectangular array beam pattern amplitude, the section in polar coordinates, the section map, magnitude contour map, etc.)
ch5figs
- 最优波束形成的空时过程特性（包括快拍模型、空时随即过程、阵列和孔径的谱采样等）-Optimal beamforming space-time process characteristics (including the snapshot model, then space-time process, arrays and spectral sampling of the aperture, etc.)
comtrade
- 本程序包包含两个程序和一个文档。两个程序为二进制与ASCII码之间的转换，文档为comtrade数据格式标准文档。-This package contains two procedures and documentation. Two programs for the conversion between binary and ASCII code, documentation comtrade data format standard document.
phase_selection
- 本程序为故障选相程序，可以区分接地与不接地故障。没有做故障发生判断，最好在故障时启动。-This program is the fault phase selection procedures, can differentiate between grounding and ground fault. Not make a fault judgment.
wave_method_fault_location
- 本程序是利用单端电气量依据行波原理实现故障测距的程序，需要较高的采样率以提高精度。-This procedure uses traveling wave principle of the single-terminal electrical information in accordance with the procedure of fault location, it requires a higher sampling rate in order to improve accuracy.
SquareLoop
- MATLAB 平方环的设计图，具体我也看不懂-square ring
BER
- matlab和optisystem联合调试用的误码率计算程序，经过测试，使用简单。-matlab and optisystem debug the error rate calculation procedure, tested, simple to use.
AmplitudeModulator
- matlab和optisystem调试用的幅度调制程序，在optisystem里面使用matlab组件然后使用。-matlab and optisystem debugging with the amplitude modulation process, component and then use the optisystem inside Matlab.