资源列表
EV_Charge_Diode_20120516
- 电池充电模型的搭建，可以对电池进行充电同时故障时可对负载供电-Built battery charging models, you can charge the battery power to the load while failure can
Fig6x1
- 直流驱动电机的matlab仿真文件，可以直接仿真结果-DC drive motor matlab simulation files, simulation results can be directly
buck-fuzzy.rar
- DC converter with fuzzy contoller,DC converter with fuzzy contoller
new21
- boost电路仿真，带有MPPT算法控制最大功率跟踪-boost MPPT
statecomxing
- 关于链式STATOM星形接法的研究，通过matlab绘制了仿真电路图-study on Y-STATCOM
IGBT
- 电压型控制的IGBT不需要栅极驱动电流，但由于栅极输入端有一个大电容，使在驱动时形成一很窄的脉冲栅极驱动电流，且IGBT容量越大，该脉冲电流的峰值越大，例如，200A/1200V的IGBT的开通电流的脉冲峰值约达到1.5A。SKHI驱动器既能承受这种高峰值栅极电流-gate drive current, but because the gate input has a large capacitance, so that the formation of a very narrow gate d
solar_buck_final
- solar_buck_final是我编写的用于基于buck电路的光伏发电系统，有MTTP最大功率跟踪，PWM调制，能直接出结果-Solar_buck_final is the photovoltaic power generation system that I have written for the buck circuit, and has the MTTP maximum power tracking, PWM modulation, can directly result
unsteadyflow
- 明渠非恒定流计算程序，水力学专业的肯定能用的到的哦！-unsteady flow
XB_Flow
- XB模式下的配电系统潮流计算，快速分解法，迭代求解配电网络的运行状态-XB mode of distribution system power flow calculation, the operational status of rapid decomposition, iterative solution distribution network
case14cumulant
- 应用半不变量法实现14节点随机潮流计算 考虑了发电机组出力和负荷的随机性-case14 cumulant
boost
- 利用matlab设计要求：输入电压范围3.5-4.5VDC，输出电压5VDC，最大输出功率10W，要求纹波峰峰值小于100mV，稳态误差小于50mV，最大转换效率超过95%，50%-100%输出功率范围内效率均超过90%(The range of input voltage 3.5-4.5VDC, output voltage is 5VDC, the maximum output power of 10W, peak ripple requirement is less than 100mV,
30节点系统最优潮流计算
- 30节点系统最优潮流计算，自编程序，可供最优潮流计算研究初学者提供系统分析；(30 node system optimal power flow calculation, self compiled procedures for optimal power flow calculation, beginners to provide system analysis;)