搜索资源列表
Run_time_calibration_of_the_internal_RC_oscillator
- 如何通过UART来校准内部RC振荡器。这种方法是基于LIN协议上使用的方法。-Run-time calibration of the internal RC oscillator (19 pages, revision A, updated 09/04) This application note describes how to calibrate the internal RC oscillator via the UART. The method used is based on t
PCD5003A
- The PCD5003A is a very low power decoder and pager controller specifically designed for use in new generation radio pagers. The architecture of the PCD5003A allows for flexible application in a wide variety of radio pager designs. The PCD5003
UART_1
- DSPIC30F5011串口测试程序，开发环境为MPLAB，设置时钟晶振4MHZ-DSPIC30F5011 serial port test program, the development environment MPLAB, set the clock oscillator 4MHZ
7MSP430F149-use-USART1-to-define-P4
- 使用MSP430F149芯片，透过串口与电脑通信，波特率9600,8数据，无校验。使用32.768k晶振，使用P3.6和P3.7口作为发送和接收口，使用异步通信USART1，采用查询形式。实现通信，当单片机接收到以S结尾以W开始的字符串时，单片机会把中间的数据赋值给P4口。-MSP430F149 chip through the serial port to communicate with the computer, baud rate 9600 data, no parity. 32.768
USART_for_ATmega32or16
- for USART initialization see Examples of UBRR Settings for Commonly Used Oscillator Frequencies table in atmega32 s datasheet or caculate fosc UBRR= ------------- - 1 16 X Baud Rate for at 16MHz freq. for 9600 baud rate function will be Us
KU_F803（进度条的函数）
- 本程序为Franklin/keil C51源程序，可以在所有51系列（或兼容）单片机中运行 程序中给出了设计方法,通过修改TIMEth使本程序适用于各种晶振及各种波特率.(This program is a franklin/keil c51 source program, can run in all 51 series (or compatible) single chip computer program gives the design method, through modifying