搜索资源列表
usb061
- 基于凌阳SPCE061A芯片的USB通讯可实现1.通过USB通讯，PC端应用程序能够控制LED灯的亮灭；2.PC端应用程序发送小于65字节的字符串给SPCE061A,SPCE061A接收PC发送的小于65字节字符串后将接收到的字符串发送给PC，PC接收字符并显示在界面。-based Sunplus SPCE061A USB chip can achieve a communication. USB communications, PC-side applications to control t
KeybdEmuSupportUSB
- 可以模拟按键向驱动发送IRP请求，过一些保护-Can simulate the key to the drive to send IRP request, some protection
USBdebug.zip
- 非常好用的usb调试小工具，可以捕获数据和发送数据。PC端使用。可以用来调试USB接口外设。,Very useful gadget usb debugger, you can capture data and send data. PC client to use. USB interface can be used to debug peripheral.
KeybdEmuSupportUSB.zip
- 可以模拟按键向驱动发送IRP请求，过一些保护,Can simulate the key to the drive to send IRP request, some protection
FTDI232
- FTDI232 Chip (USB to Serial) convertor driver for BASCOM AVR. (BASIC Language) This sample driver gives you the ability to send text to USB port or read available chars from the USB port. Written in BASCOM AVR 1.11.9.x
SlaveFIFO
- 用vc++6.0实现与usb设备通信的功能，可收发数据。-Achieved with the vc++6.0 and the usb device communication function, can send and receive data.
usb1
- ISP1581 演示程序，本程序演示的是利用端点1进行收发通信-ISP1581 demo program, demonstration of this procedure is to use one endpoint to send and receive communications
usb2
- ISP1581芯片编程例子，本程序演示的是利用端点2和厂商请求来进行收发的例子-ISP1581 chip programming examples, the procedures are demonstrated using endpoint 2, and manufacturers to send and receive requests for examples of
SEND
- Below, you will find an assortment of documentation to assist you through every step of your USB development experience.
AA1
- 实现学习板通过USB端口与PC机通信，用户通过端点1(EP1)发 送0x11将启动ADC转换并将采样结果通过EP1发送给PC机， 用户通过EP1发送0x99停止ADC转换-The achievement of learning board with the PC through the USB port communication, the user through the endpoint 1 (EP1) Send 0x11 to start sampling and ADC co
Bulkendpointtosendandreceiveunlimited
- 批量端点无限发送与接收，在KEIL中运行，适用于CYUSB的开发和仿真-Bulk endpoint to send and receive unlimited, in KEIL run for the development and simulation CYUSB
serial_and_usb
- 由电脑圈圈的原程序改写，使用串口3，波特率9600连接上EDNCHINa，电脑圈圈的USB开发板可以测试从串口发送到USB接收的数据，这是上位的程序，很有参考价值。下位机程序另发。-By a computer program to rewrite the original circle, use the serial port 3, connected to the 9600 baud rate EDNCHINa, the computer' s USB development board
GSMusb
- 通过移动的GSM猫与计算机usb接口相连，实现计算机发送短信功能-The GSM mobile usb cat interface with a computer connected to the computer to send text messages to achieve functions
CH341
- CH341是一个USB总线的转接芯片，通过USB总线提供串口、打印口或者并口。 在串口方式下，CH341提供串口发送使能、串口接收就绪等交互式的速率控制信号以 及常用的MODEM联络信号，用于将普通的串口设备直接升级到USB总线。 -CH341 is a USB bus adapter chips, provided through the USB serial bus, printer port or parallel port. In serial mode, CH341 Send
HT82M99E_USB_send_datas_to_PC
- USB 单片机发送数据上传到PC端。中断模式上传。适用于小批量数据。-MCU (usb type) send datas to the PC.Using inrrupt to send the datas.Special for little datas.
USBDA
- 通过USB接口给单片机发送数据，再给DA，输出模拟信号-To the microcontroller through the USB interface to send data to give DA, the output analog signal
USBLCD
- 通过USB接口给单片机发送数据，然后单片机再将其显示在LCD上-To the microcontroller through the USB interface to send data, and then microcontroller and then display it on the LCD
cy68013a_led
- 通过计算机上位机发送指令控制CY68013AUSB开发板的LED.-Host computer to send commands through the computer control CY68013AUSB development board LED.
usb_send_msg
- 在vc 6.0平台上编写的usb发送数据的程序！可以很好的学习usb协议-In vc 6.0 platform prepared to send data through usb! Usb protocol can be a good learning
GSM
- 基于GSM短消息的交通信息服务系统。以过usb口与NOKIA手机连接为例，实现对手机发信息的控制。-GSM short message on the traffic information service system. With NOKIA for example, send information to achieve control of the phone.